User manual

Panel Controller Remote keypad | en 37
Bosch Sicherheitssysteme GmbH Operation guide F.01U.076.969 | 6.0 | 2010.04
7 Remote keypad
In the FSP-5000-RPS programming software, the address of a panel to which a connection is
automatically made from the remote keypad can be entered in the dialog regarding the node
of the remote keypad. In addition, further panels with which a connection can be made can
also be assigned.
It is not possible to log out of the automatically assigned connection. A connection can be
established with other panels without any further queries.
7.1 Operation and display
The prerequisite for operating a remote keypad is that an operator with an access
authorization > 1 is logged in. If an operator with access authorization = 1 is logged in, no
LEDs are activated and no messages displayed. If no operator is logged in, only the standby
screen is displayed.
If the remote keypad is not connected to a panel, the following symbol is displayed on the
standby display and in the status bar:
The following functions cannot be executed from the remote keypad via a remote connection:
– LED, foil, display and display touch test
– Adjust touch screen
NOTICE!
It is possible to specify in the FSP-5000-RPS programming software that messages are to be
displayed on the remote keypad, even if no operator is logged in.
NOTICE!
In the FSP-5000-RPS programming software, a time span can be specified after which an
operator who is logged in to the panel controller is logged out.