User manual

38 en | Alarm Panel Controller
F.01U.076.969 | 6.0 | 2010.04 Operation guide Bosch Sicherheitssysteme GmbH
8Alarm
This chapter contains information about the following points:
– Section 8.1 Types of alarm, page 38
– Section 8.2 Entry delays, page 39
– Section 8.3 Day and night mode, page 40
– Section 8.4 Alarm message to the panel, page 41
Refer to theFire alarmchapter for the following topics:
– Section 9.2 Acknowledging a message, page 44
– Section 9.3 Switching off internal buzzer, page 45
– Section 9.4 Switching external signaling devices on and off, page 45
– Section 9.5 Resetting external signaling devices and transmission devices, page 45
– Section 9.6 Triggering fire verification, page 46
– Section 9.7 Resetting alarm message, page 47
– Section 9.8 Bypassing detectors, page 48
8.1 Types of alarm
On the panel controller, a distinction is made between the following types of alarm:
– Fire
– Heat
– Smoke
– Water
– Supervisory
Depending on the configuration, external transmission devices (e.g. fire department),
signaling devices (e.g. sirens and/or strobes) and fire protection systems (e.g. sprinkler
systems, fire doors) are activated.
NOTICE!
Information on how to handle a fire alarm can be found in Section 9 Fire alarm.
NOTICE!
Depending on the configuration, the manner in which alarm displays are shown and handled
in this guide may differ from the guide on the system.
NOTICE!
If an alarm delay is programmed for the detector generating the alarm, the alarm signal is not
transmitted immediately and the message can be checked; see Section 8.2 Entry delays.