User manual

Panel Controller Fault message | en 49
Bosch Sicherheitssysteme GmbH Operation guide F.01U.076.969 | 6.0 | 2010.04
10 Fault message
This chapter contains information about the following points:
– Section 10.1 Calling up fault indication, page 49
– Section 10.2 Trouble message on the panel, page 50
– Section 9.3 Switching off internal buzzer, page 45
– Section 10.3 Resetting malfunction message, page 53
– Section 10.4 Isolating an element, page 53
10.1 Calling up fault indication
To display the fault messages from the alarm indication or any other menu, select the
following on the status bar:
– Fault: A list of all reported fault types and the number of faulty elements are displayed.
– Status: A list of all current messages, grouped by message type, is displayed. The number
of elements is also given in each case.
To display the fault messages, select the message category you require — in this case,
Fault.
NOTICE!
If a fire alarm is reported, the system automatically switches to alarm indication.
To return to the fault indication, select Fault on the status bar.
In the event of a fire alarm, the display automatically switches back to the alarm indication
after 30 seconds.
0
Fire
0
Control
8
Trouble
0
Bypass Status
CAUTION!
If a message does not have to be reset, it is removed from the display as soon as the fault has
been rectified.
NOTICE!
If individual elements that are combined with other elements in a group are malfunctioning,
the respective element group is displayed first of all. To display the individual elements, select
the element group you require. See also Section 10.2.5 Displaying individual elements of an
element group, page 51.