User manual

58 en | Isolate Panel Controller
F.01U.076.969 | 6.0 | 2010.04 Operation guide Bosch Sicherheitssysteme GmbH
12.3 Displaying list of all isolated elements
There are two ways to display a list of all isolated elements:
– Section 12.3.1 Using the menu, page 58
– Section 12.3.2 Via the status bar, page 58
12.3.1 Using the menu
To display a list of all isolated elements, select the following in the start menu:
1. Bypass Block
2. Block
3. Show blocked devices
A list of various element categories is displayed.
The listed figure indicates the number of isolated elements or element groups in the
relevant element category.
4. Select the element category you require, e.g. Detector.
A list of all isolated detectors is displayed.
To de-isolate isolated elements:
1. Select the element you require.
2. Select Un-block.
The element is de-isolated.
12.3.2 Via the status bar
To display a list of all isolated elements:
1. Select Bypass on the status bar.
A list of various states is displayed.
2. Select Blocked.
A list of various element categories is displayed.
The listed figure indicates the number of isolated elements or element groups in the
relevant element category.
3. Select the list field you require, e.g. Detector.
A list of all isolated elements is displayed.
To de-isolate isolated elements:
1. Select the element you require.
2. Select Un-block.
The element is de-isolated.