User manual

62 en | Diagnostics Panel Controller
F.01U.076.969 | 6.0 | 2010.04 Operation guide Bosch Sicherheitssysteme GmbH
Display touch test
To test the functionality of the touch-sensitive surface:
1. Select Diagnostics in the start menu
2. Hardware
3. Display
4. Select Display touch test.
5. Touch the touch screen.
A crosshair appears at the touched place.
Press the "back" function key to end the operation.
Adjust touch screen (calibration)
To adjust the press precision when touching the touch screen:
1. Select Diagnostics in the start menu
2. Hardware
3. Display
4. Adjust touch screen
5. Carry out the steps shown on the display.
13.4.3 Serial Interface
Select Serial interface to display the statistical data for the transmission.
13.4.4 CAN-Bus
Select CAN bus to display the status of CAN interfaces.
13.5 Panel Passport
Select Panel passport to display the following diagnostic information:
– Module
– Address
– CAN ID
– Production date
– BOM revision
– PCBA material number
– Material number
– Software version
– Build type
– Build number
– MAC address