User manual

88 en | Further functions Panel Controller
F.01U.076.969 | 6.0 | 2010.04 Operation guide Bosch Sicherheitssysteme GmbH
A new function cannot be selected until the fault/supervisory alarm and/or the fire drill have
been completed.
19.7 Alarm Counters
Show Lifetime Event Counters
During the lifetime of the panel, the following alarm messages are counted:
– External alarm: all fire messages
– Internal alarm: all alarm messages that the panel receives in day mode
– Walktest alarm: all messages from detectors switched to walktest
To display the number of alarm messages which have been counted so far:
1. Select Further functions in the start menu
2. Alarm counters
The figure after the message type shows the number of messages counted so far.
Reset counters
You can reset the alarm counter for individual alarm types to 0.
To reset alarm counters
1. Select Further functions in the start menu
2. Alarm counters
3. Mark the alarm counter you require (e.g. external alarm)
4. Select Reset
5. Confirm the message "Attention: Counter will be reset" with OK to reset the alarm
counter to 0 or select Cancel to cancel the operation.
Display switches to Alarm indication Fault indication
Fire drill after event ends Must be restarted
manually
Continue
Fire alarm Fault/
supervisory alarm
NOTICE!
In order to reset alarm counters, you need authorization level 4.