Installation guide

Remove the PC board if necessary. This is secured in the
housing with a grounding screw and snap-fit hook.
For cable entry on the upper side of the housing, use the pre-
formed round holes. For more stable insertion, M 20 x 1.5 screw
joints (PG13.5) can be used.
The cable entries on the rear are intended for direct cable entry
of flush mounted cables.
Opening the Housing
Remove the cover of the fire panel. Loosen both screws on the
underside of the housing, lift up the cover approx. 20° and
remove it.
3.2.2
14 en | Installation Conventional Fire Panel
2014.06 | 7.0 | F.01U.172.980 Bosch Sicherheitssysteme GmbH