Operation Manual

6 720 645 350 (2010/09)
10 | Operation with closed flap
4.2 If you feel too cold or too hot
You can check the current temperature on the
display. Subject to the installation location (on
the wall or in the heating appliance) and the
chosen settings, the display either shows the
room temperature or the flow temperature.
Displaying temperature settings
B Turn rotary selector one click.
Changing the temperature settings temporarily
With the flap closed, you can change the room
temperature temporarily with rotary selector
.
If the controller indicates the room temperature:
B Turn the rotary selector until the required
room temperature is displayed.
The temperature display flashes.
B Push the rotary selector.
The change applies until the next switching
time in your heating program is reached.
Afterwards, the settings of your heating
program will apply again.
If the controller indicates the flow temperature:
B Turn the rotary selector to set your heating
system WARMER or COOLER.
The position arrows on the display bar flash.
B Push the rotary selector.
The change applies until the next switching
time in your heating program is reached.
Afterwards, the settings of your heating
program will apply again.
The required room temperature is a
guide value which the weather-
compensated controller tries to
reach. Deviations from the actual
room temperature that is achieved
can, therefore, occur.
You can also permanently change
the room temperature
(Æ Chapter 5.2).