Operation Manual

6 720 645 349 (2010/09)
Menu settings INSTALLER SETTINGS (contractors only) | 47
8.2 Configuring the heating system
Installer settings: System configuration
For menu structure and setting ranges
Æ page 43.
Use this menu if you want to configure the system
automatically or manually. For example, during
commissioning or when altering the system.
B Set DIP switch at IPM 1 to 1.
B Switch ON the system.
B Set FB 10 or FB 100 to 1.
B Start automatic configuration.
B Check the other menu points under System
configuration and, if necessary, adjust
manually to suit the current system.
8.3 Parameters for heating
Installer settings: Heating parameters
For menu structure and setting ranges Æ page 44.
Use this menu if you want to adjust the
parameters for the heating system. For example,
the heating curve can be calculated with these
parameters.
Menu: Heating parameters > Heating circuit
type
B Selecting the heating type:
– Foot point/End point: Default settings for
a level heating curve are used according to
the classic base point/end point method.
– Underfloor heating: Default settings for an
uneven heating curve as in an underfloor
heating circuit are used.
– Radiators: Default settings for an uneven
heating curve as in a radiator heating
circuit are used.
– Convectors: Default settings for an uneven
heating curve as in a convector heating
circuit are used.
For system examples, see the IPM
manual. For further systems, see
the technical guides.
Set the flow temperature controller
on the heating appliance to the
maximum required flow
temperature.
Parameters not used in a particular
type of heating system are not
shown.