Operation Manual

English | 27
Bosch Power Tools 1 609 929 L56 | (4.6.08)
Technical Data
Assembly
Mounting the Protective Devices
f Before any work on the machine itself, pull
the mains plug.
Note: After breakage of the grinding disc during
operation or damage to the holding fixtures on
the protection guard/power tool, the machine
must promptly be sent to an after-sales service
agent for maintenance (for addresses, see sec-
tion „After-sales Service and Customer Assist-
ance“.
Protection Guard for Grinding
Release the clamping lever 8. Place the protec-
tion guard 6 with the encoding key 7 engaging
into the groove on the spindle collar until the
shoulder of the protection guard is seated
against the flange of the power tool, and turn
the protection guard 6 to the requested posi-
tion. Lock the clamping lever 8.
f Adjust the protection guard 6 in such a man-
ner that sparking is prevented in the direc-
tion of the operator.
The tightening tension of the clamp from the
protection guard 6 can be changed by loosening
or tightening the adjustment screw 9. Ensure
that the protection guard 6 is tightly seated and
check regularly.
Angle Grinder GWS ...
Professional
22-180
LVI
22-230
LVI
24-180
LVI
24-230
LVI
Article number
3 601 ... H90 D.. H91 C..
H91 D..
H92 F.. H93 F..
H93 H..
Rated power input
W 2200 2200 2400 2400
Output power
W 1500 1500 1600 1600
Rated speed
rpm 8500 6500 8500 6500
Grinding disc diameter, max.
mm 180 230 180 230
Thread of grinder spindle
M 14 M 14 M 14 M 14
Thread length (max.) of grinder spindle
mm 25 25 25 25
Kickback stop
z zzz
Restarting Protection
z zzz
Reduced starting current
z zzz
Rotatable main handle
– – z z
Weight according to EPTA-Procedure
01/2003
kg 5.3 5.4 5.4 5.5
Protection class
/II /II /II /II
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries,
these values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines
may vary.
OBJ_BUCH-429-005.book Page 27 Wednesday, June 4, 2008 11:55 AM