Operation Manual

English - 1
The numbering of the machine elements refers to
the illustration of the machine on the graphics
page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 Thread for auxiliary handle (3x)
2 Spindle lock button
3 On/Off switch
4 Auxiliary handle
5 Mounting flange
6 Grinder spindle
7 Protection guard
8 Adjustment screw
9 Clamping lever
10 Grinding/cutting disc*
11 quick-clamping nut*
12 Clamping screw
13 Coded projection
14 Guard, grinding cup*
15 Grinding cup*
16 Clamping nut*
17 Two-pin spanner for clamping nut*
18 Hand guard*
19 Rubber sanding plate*
20 Sanding sheet*
21 Round nut*
22 Cup brush*
23 Diamond cutting disc*
24 Cutting guide with dust extraction
protection guard*
25 Handle unlocking button
26 Handle
27 Cutting grinder stand*
* Not all of the accessories illustrated or described are
included as standard delivery.
Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the ma-
chine are: Sound pressure level: 93 dB (A);
sound power level: 106 dB (A).
Wear hearing protection!
When using the standard auxiliary handle, the
typically weighted maximum acceleration is
5.2 m/s
2
.
When using the vibration-dampening auxiliary
handle, the hand-arm vibration at the auxiliary
handle is typically below 2.5 m/s
2
.
Tool Specifications
Angle Grinder GWS ...
PROFESSIONAL
24-180 JBX 24-180 BX 24-230 JBX 24-230 BX
Article number 0 601 863 8.. 0 601 863 1.. 0 601 864 8.. 0 601 864 1..
Rated power input [W] 2 400 2 400 2 400 2 400
Output power [W] 1 600 1 600 1 600 1 600
No-load speed [rpm] 8 500 8 500 6 500 6 500
Grinding disc dia., max. [mm] 180 180 230 230
Reduced starting current ● – ● –
Grinder spindle thread M 14 M 14 M 14 M 14
Weight according to EPTA-
Procedure 01/2003
[kg] 5.3 5.3 5.3 5.3
Protection class / II / II / II / II
Inrush currents cause short-time voltage drops. Under unfavourable power supply conditions, other equipment may be af-
fected. If the system impedance of the power supply is lower than 0.25 Ohm, disturbances are unlikely to occur.
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltages and models for specific countries, these
values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.
Machine Elements
Noise/Vibration Information
1 609 929 H82.book Seite 1 Dienstag, 3. Mai 2005 3:11 15
16 • 1 609 929 H82 • TMS • 28.04.05