Technical data

2. The

new hard disk parameters are automatically identified by the system.

If the operating system does not boot automatically, the power supply is

to be interrupted for at least 10 seconds. A restart needs to be carried out

again.

3. After properly booting the PC the user data and the operating system set‐

tings for the normal mode have to be restored.

8.3 CMOS Battery

The battery used for buffering the RAM and the clock has a limited service life,

see also chapter 4.8 "Wear Parts" on page 23.

This lithium battery must not be changed by the user. The battery may only be

exchanged by the Bosch Rexroth Service (see chapter 12 "Service and Sup‐

port" on page 77) or by personnel trained and authorized by the Service.

Warning: Battery safety. Risk of fire, explosion,

and burns.

WARNING

Do not recharge, disassemble, crush, heat above 100°C (212°F) or incinerate.

Dispose of used battery promptly. Keep away from children!

8.4 Battery Pack

For

the uninterruptible power supply of VPB 40.1 an external battery pack for

control cabinet mounting is available.

Connection battery pack

The battery pack is connected with the 2-pin male connector strip X19 situated

at the connector panel on the upper side of the PC box. For this, use an un‐

shielded cable with line cross-sections of at least 1.5 mm

. The cable length is

maximum 3.0 m.

Bosch Rexroth provides ready-made cables with a length of 1.0 m and 3.0 m,

see chapter 11.2.2 "Battery Pack and cables" on page 74.

Akku-Pack

X19

VPB 40.1

Battery pack

Fig.8-2: External battery pack

To connect the external batteries proceed as follows:

1. Select a suitable position for mounting the battery in the control cabinet.

The battery pack should be mounted in a cool place in the control cabinet

because the surrounding air temperature directly influences the service

life of the battery. A required mounting position can be selected (see the

following figures).

DOK-SUPPL*-VPB*40.1***-PR02-EN-P

Rexroth IndraControl VPB 40.1 Control Cabinet PC

Bosch Rexroth AG 49/81

Maintenance and Installation