Instruction manual

7
Light
The oven light can be turned on manually to facilitate cleaning.
Turning on the oven light
Turn the function control knob to the
^ position.
The light will come on. The temperature control knob must be
turned off.
Turning the oven light off
Turn the function control knob to the
Ûposition.
Removing and refitting the wire shelves or left
and right hand side rails
The wire shelves or left and right hand side rails can be
removed for cleaning. The oven must be cold.
Release the guides or rails
1. Lift the front of the guide or rail and release it (figure A).
2. Then pull the guide or rail forwards completely and remove it
(figure B).
Clean the guides or rails with detergents and a sponge. The
use of a brush is recommended for stubborn stains.
Install the wire shelves or rails
1. First insert the shelf or the rail in the rear groove by pushing it
back slightly (figure A)
2. then insert it in the front groove (figure B).
Wire shelves or rails can be adjusted on the left and right hand
side. Their curvature should always be face down.
Unhooking and hanging the oven door
The front panel can be unhooked to help remove the oven door
and clean the glass panels.
The oven door hinges are fitted with a locking lever. The door
cannot be unhooked if the locking lever is closed (figure A).
Once the locking lever has been opened to unhook the door
(figure B), the hinges will be locked in position. This prevents
the door from suddenly closing.
: Risk of injuries.!
The hinges may close suddenly if they are not locked in
position by the lever. Note that the locking levers are always
closed, apart from when unhooking the door, when the levers
must be open.
Zone Cleaning products
Front panel Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Do not use a glass cleaning
product or a glass scraper.
Stainless steel Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Immediately remove any
water marks, grease, cornflower or egg
white stains since corrosion could occur
underneath these marks or stains.
Special products for the care of stain-
less steel and which are suitable for hot
surfaces may be obtained from Techni-
cal Assistance Service centres and spe-
cialist retail outlets. Use a very fine soft
cloth to apply the cleaning product.
Glass panel Glass cleaning products:
Clean using a soft cloth. Do not use a
glass scraper.
Glass panels on
oven door
Glass cleaning products:
Clean using a soft cloth. Do not use a
glass scraper.
Oven interior Hot water with a little soap or water and
vinegar:
Clean with a dishcloth.
If very dirty, use a stainless steel
scourer or special oven cleaning prod-
ucts. These must only be used when the
oven interior is cold.
Glass cover for the
oven light
Hot water and a little soap:
Clean with a dishcloth.
The seal
Do not remove!
Hot water and a little soap:
Clean with a dishcloth. Do not rub.
Wire shelves or rails Hot water and a little soap:
Soak and clean using a dishcloth or
brush.
Sliding guides Hot water and a little soap:
Clean with a dishcloth or a brush. Do
not leave this to soak or wash in a dish-
washer.
Accessories Hot water and a little soap:
Soak and clean using a dishcloth or
brush.
%
$
%
$
%
$