BOSCH INSTALLATION INSTRUCTION MANUAL for Bosch Electric Built-in Single & Double Oven Models HBL 73oo/74oo/75oo/76ooand Models HBN 74.o/75.o/76.o BEFORE YOU BEGIN, READ THESE ][NSTRUCTI[ONS COMPLETELY AND CAREFULLY Save these instructions for the local electrical inspector's Please leave this manual with owner for future reference. Please keep this manual for future use. reference° VEUILLEZ LIRE ATTENTIVEMENT CE MANUEL AVANTDE COMMENCER UINSTALLATION 2002 BSH Home Appliances (. orp.
Technical Data ..................................................................................................... HBL Models: Single Oven, Double Oven .......................................................... HBN Models: Single Oven, Double Oven ......................................................... Undercounter Installation ........................................................................................ Single Oven ........................................................................
INTRODUCTION POWER PleasereadtheseinstructionsCOMPLETELY AND CAREFULLY.Theywill saveyou time and The oven must be supplied with the proper voltage and frequency. The oven is mamffactured to be connected to a three=wire or four-wire, single phase, 240 Volt, 60 Hz AC electlical supply on a separate circuit fused on both sides of the line. If a 208 Volt eflbrt and help to ensure optimum oven pertbnnance. Be sure to observe all WARNINGS.
TECHNICAL SINGLE DATA for HBL 73o./74o./75o./76o. OVEN For cutout dimensk_ns Preparing see folk_wmg section titled: Location and Maximum Single Oven Models Volts Hertz HBL 732A UC 240/208 HBL 735A UC HBL 736A UC Connected Load Watts Convection Amperes @240V/208V @240V/208V 60 15.4/17.2 3,600/3,500 No 240/208 60 15.4/17.2 3,600/3,500 No 240/208 60 15.4/17.2 3,600/3,500 No HBL 742A UC 240/208 60 15.8/17.6 3,650/3,550 Yes HBL 745A UC 240/208 60 15.8/17.
TECHNICAL SINGLE DATA for HBN 74o./75o./76o. OVEN For cutont dimem;ions Preparing see follnwing section titled: Location Electrical Ratings and Maximum Connected Load Watts Convection Oven Amperes @240V/208V @240V/208V 60 15.8/17.6 3,650/3,550 Yes 240/208 60 15.8/17.6 3,650/3,550 Yes 240/208 60 15.8/17.
UNDERCOUNTER INSTALLATION, SINGLE OVEN I Ovenelectricalsupply:Locatejunctionbox I u: Z O 00 I E @ o o I in adjacent cabinet or betow bottom I I supportsurface. I I NBL Node,s: 28"openingwidth I I I HBN Models: 25-3/8"openingwidth O I I C-0 Bottomsupportsurfacemustbesolid,level and able to supportat least 150 Ibs. I I 1/4" rain.distancebetweenoven door frameand adjacentdoorsor drawerfronts. Toespacearea . HBLModels:29ol/4"widthofovendoorframe..
WALL INSTALLATION, SINGLE OVEN * HBL: HBL73../74../75../76.. * HBN:HBN 74../75../76.. Secureovento cabinetusingthescrewsprovided.Screws should be inserted through the mounting holes in the positionsindicatedin the frame (opendoor to see frame and mountingholes). Donot overtightenscrews. Note: 1. Do not slide oven across floor. Damage to floor covering or floor could result. 6. Be carefld when placing oven. DO NOT pinch the conduit between the oven back or v,_alland the inner cabinet v,_allor floor. 2.
WALL INSTALLATION, DOUBLE OVEN g _.5-3/8" openingwidth \ * HBL: HBL73../74../75../76.. * HBN: HBN74../75../76.. Secureoven to cabinet using the screws provided.Screwsshould be inserted through the mountingholes in the positionsindicatedin the frame (opendoor to seeframe and mountingholes).Do not overtightenscrews. Note: 1. Do not slide oven across floor. Damage to floor covering or floor could result. 6. Be careflll when placing oven.
ELECTRICAL Before installing the trician verify that your equate electrical service oven will not overload SUPPLY WIRING oven have a qualified elechome is provided with adand that the addition of the the branch circuit on which it is to be installed. A separate three-wire or fourwire single phasQ 240 Volt, 60 Hz, or a 208 Volt, 60 Hz branch circuit is required. NOTE: For use with 208 V, 60 Hz supply voltage, see ( o_ectmg to = 08 _o/t Circuit.
In Canada: Wiring rrmst conlbrm to Canadian C22.1- latest edition. Electrical Code You can obtain a copy of the Canadian Electrical Code by writing: Canadian Standards Association 178 Rexdale Boulevard Rexdale (Toronto), M9W 1R3 4. Wire size (COPPER Ontario, Canada 240 Volt selwice is not available. This option must be accessed with the oven connected to power source, with the oven door (_¢pper ore, i, double ore,) open, and using the following sequence: 1. Touch CANCEL pad. 2.
ELECTRICAL CONNECTIONS This appliance is manu_i_ctured with a green GR()I_YND wire connected to the oven chassis. After making sure that the power has been turned oft, connect the flexiNe conduit flom the oven to the junction box using a U.L. listed conduit connector. Figures A and B and the instructions provided below present the most common way of connecting the ovens. Your local codes and oldinances, of course, take precedence to these instructions.
FINAL CHECKLIST 4. Set the clock by following these steps: a). Touch TIME pad. To prevent improper connections leading to dan> b). age of electrical components and so voiding the warranty, the following steps must be performed: until CLOCK appears. c). Touch TIME pad. d). Turn rotary knob in either direction. The time displayed will change in i 0-minute increments and indicate AM or PM. Turn the 1.