Instruction manual

ELECTRICAL CONNECTIONS
This appliance is manu_i_ctured with a green GR()I_YND wire connected to the oven chassis. After making
sure that the power has been turned oft, connect the flexiNe conduit flom the oven to the junction box using
a U.L. listed conduit connector. Figures A and B and the instructions provided below present the most
common way of connecting the ovens. Your local codes and oldinances, of course, take precedence to these
instructions. Complete electrical connections accolding to local codes and ordinances.
3-WIRE BRANCH CIRCUIT
Refer to Figure A, where local codes allow the
connection of GR()UND wire flom the oven to the
branch circuit NEUTRAL wire (grey or white col-
ored wire):
* If local codes permit, connect the green
GROUND wire flom the oven and the white wire
flom the oven to the branch circuit NEUTRAL
wire (grey or white colored wire).
Connect the red and black leads fiom the oven to
the corresponding leads in the junction box.
Figure A
Junction box
Redwires "_""_"_,
Bareor _
greenwire _ LI_
Cable
fromoven
Cablefrom
powersuppJy
U.kAisted conduit connector
4oWIRE BRANCH CIRCUIT
Re_}r to Figure B:
, Connect the green GR()UND wire flom the oven
to the GROUND wire in the junction box (bare
or green colored wire).
, Connect the red and black leads fiom the oven to
the corresponding leads in the junction box.
, Connect the white wire fiom the oven to the NEU-
TRAL (grey or white) wire in the junction box.
Figure B
Junctionbox
Redwires
Ungrounded neutrN
Cablefrom
powersupply
¢Thitewires
Bareor
greenwire
CaNefrom
oven
Blackwires
U.L.-listedconduitconnector
11