Installation Instructions
Table Of Contents
- Built-in Single, Double and Combination Ovens
- en-us
- Table of contents
- 1 IMPORTANT SAFETY INSTRUCTIONS
- 2 Before you begin
- 3 Package removal
- 4 Installation requirements
- 5 30" Single oven dimensions
- 6 30" Double oven dimensions
- 7 30" Combination oven dimensions
- 8 27" Single oven dimensions
- 9 27" Double oven dimensions
- 10 Prior to installation
- 11 Installing the ovens into the cabinet
- 12 Electrical connection
- 13 Testing the operation
- 14 Customer Service
- fr-ca
- Table des matières
- 1 IMPORTANTES CONSIGNES DE SÉCURITÉ
- 2 Avant de commencer
- 3 Élimination de l'emballage
- 4 Exigences d'installation
- 5 Dimensions pour les fours simples de 30 po
- 6 Dimensions du four double de 30 po
- 7 Dimensions du four combiné de 30 po
- 8 Dimensions du four simple de 27 po
- 9 Dimensions du four double de 27 po
- 10 Avant l'installation
- 11 Installation des fours dans l'armoire
- 12 Raccordement électrique
- 13 Opération d’essai
- 14 Service à la clientèle
- es-mx
- Tabla de contenidos
- 1 INSTRUCCIONES DE SEGURIDAD IMPORTANTES
- 2 Antes de empezar
- 3 Eliminación del embalaje
- 4 Requisitos de instalación
- 5 Medidas para hornos individuales de 30"
- 6 Medidas para el horno doble de 30"
- 7 Medidas para hornos de combinación de 30"
- 8 Medidas para hornos individuales de 27"
- 9 Medidas para el horno doble de 27"
- 10 Antes de la instalación
- 10.1 Elevación del aparato
- 10.2 Conexión del tubo del horno rápido o del horno de aire caliente y vapor al horno inferior
- 10.3 Conexión del microondas al horno inferior
- 10.4 Ensamblaje de las dos unidades del horno de combinación
- 10.5 Extracción de la puerta del horno (en modelos convencionales con bisagra inferior)
- 11 Instalación de los hornos en el gabinete
- 12 Conexión eléctrica
- 13 Comprobación del funcionamiento
- 14 Servicio de atención al cliente
en-us Prior to installation
14
9.2 27" Double oven traditional installation
*Junction box location: above, left or right of the unit within
reach of the flexible conduit.
Control panel overlap: min. 3/8" (10mm) to max.
2" (51mm).
9.3 27" Double oven flush mount installation
Flush installation requires two side cleats to be attached
inside the cabinet frame, recessed from the front.
Top view
Reveal cleats
Flush inset depth
Side view
Reveal cleats
Flush cutout height
Prior to installation
10 Prior to installation
Prior to installation
Carry out these steps to prepare your appliance for instal-
lation.
10.1 Lifting the appliance
Follow these recommendations to prevent injury and dam-
age to the appliance during lifting.
CAUTION
DO NOT attempt to lift the unit by holding the oven's upper
heating element.