Installation Guide
Table Of Contents
- Built-in Single, Double and Combination Ovens
- en-us
- Table of contents
- 1 IMPORTANT SAFETY INSTRUCTIONS
- 2 Before you begin
- 3 Package removal
- 4 Installation requirements
- 5 30" Single oven dimensions
- 6 30" Double oven dimensions
- 7 30" Combination oven dimensions
- 8 27" Single oven dimensions
- 9 27" Double oven dimensions
- 10 Prior to installation
- 11 Installing the ovens into the cabinet
- 12 Electrical connection
- 13 Testing the operation
- 14 Customer Service
- fr-ca
- Table des matières
- 1 IMPORTANTES CONSIGNES DE SÉCURITÉ
- 2 Avant de commencer
- 3 Élimination de l'emballage
- 4 Exigences d'installation
- 5 Dimensions pour les fours simples de 30 po
- 6 Dimensions du four double de 30 po
- 7 Dimensions du four combiné de 30 po
- 8 Dimensions du four simple de 27 po
- 9 Dimensions du four double de 27 po
- 10 Avant l'installation
- 11 Installation des fours dans l'armoire
- 12 Raccordement électrique
- 13 Opération d’essai
- 14 Service à la clientèle
- es-mx
- Tabla de contenidos
- 1 INSTRUCCIONES DE SEGURIDAD IMPORTANTES
- 2 Antes de empezar
- 3 Eliminación del embalaje
- 4 Requisitos de instalación
- 5 Medidas para hornos individuales de 30"
- 6 Medidas para el horno doble de 30"
- 7 Medidas para hornos de combinación de 30"
- 8 Medidas para hornos individuales de 27"
- 9 Medidas para el horno doble de 27"
- 10 Antes de la instalación
- 10.1 Elevación del aparato
- 10.2 Conexión del tubo del horno rápido o del horno de aire caliente y vapor al horno inferior
- 10.3 Conexión del microondas al horno inferior
- 10.4 Ensamblaje de las dos unidades del horno de combinación
- 10.5 Extracción de la puerta del horno (en modelos convencionales con bisagra inferior)
- 11 Instalación de los hornos en el gabinete
- 12 Conexión eléctrica
- 13 Comprobación del funcionamiento
- 14 Servicio de atención al cliente
en-us Electrical connection
22
Electrical connection
12 Electrical connection
Electrical connection
Read these instructions to safely connect your appliance to the electrical supply.
12.1 Electrical requirements
Make sure your electrical installation supports the follow-
ing requirements.
This appliance must be supplied with the proper voltage
and frequency and connected to an individual, properly
grounded branch circuit, protected by a circuit breaker or
fuse. To know the circuit breaker or fuse required by your
model, see the rating plate to find the wattage consump-
tion and refer to the ratings table to get the circuit breaker
or fuse amperage.
All oven models on the front cover of this Installation In-
structions are dual rated, designed to be connected to ei-
ther 208V or 240VAC, 60Hz, 4-wire, single-phase
power supply.
Model Circuit required Watts @ 240V Circuit required Watts @ 208V
HBL5351UC,
HBL5344UC
30A 6300 30A 4800
HBL5451UC, HB-
N8451UC,
HBL8454UC,
HBL8453UC,
HBL8443UC,
HBL8444LUC,
HBL8444RUC,
HBLP454UC,
HBLP451UC,
HBLP451LUC,
HBLP451RUC
30A 6400 30A 4800
HBL5551UC 40A 6000 30A 4500
HBL5651UC,
HBL8651UC,
HBL8642UC
40A 8500 40A 6500
HBL57M52UC,
HBL87M53UC
40A 8000 40A 6500
HBL5754UC,
HBL8753UC,
HBL8743UC,
HBLP752UC
40A 9600 40A 8400
HBN8654UC 40A 8600 40A 6600
HBLP651UC,
HBLP651LUC,
HBLP651RUC
40A 9200 40A 7000
HSLP751UC 40A 8400 40A 6400
12.2 Location of the power outlet
Before you install the appliance, check the location of the
power outlet.
¡ If the electrical supply is located in the cabinet opening,
the electrical connection must be made prior to placing
the oven in the opening.
¡ If the electrical supply is in an adjacent cabinet, electri-
cal connection can be made after placing the oven in
the opening.
12.3 Routing the electrical conduit cable
Requirements
¡ A hole in the cabinet has been prepared to route the
electric conduit from the oven to the junction box.
¡ Serviceability must be maintained. Do not shorten the
electric conduit cable. Route the electric conduit cable
in a way to permit temporary removal of the oven.
▶
The electrical conduit cable swivels where it is con-
nected at the oven. Rotate the electric conduit cable up-
ward or downward and direct it through the prepared
hole in the cabinet.