YOUR LIFE. OUR INSPIRATION, Freestanding Dual Fuel Range Safety ......... Preparation ...... Installation ......
Important Safety Instructions ,,, Our Table of Contents Important Safety Instructions .......................................................................................... Preparation ................................................................................................................... Installation .................................................................................................................... Final Steps ..............................................................
Your Life ... A IIvIPORTANT SAFETY INSTRUCTIONS f F WARNING For Massachusetts Installations: Before installing, turn power OFF at the service panel. Lock service panel to prevent power from being turned ON accidentally.
Steps 1 through 1. Install ,,, Our 4: Preparation Ventilation Bosch strongly recommends the installation of a ventilation hood above this range. For most kitchens a certified hood rating of not less than 300 CFM is recommended. The range hood must be installed according to instructions furnished with the hood. 2. Prepare O Cabinets This unit is designed for installation near adjacent walls and projecting surfaces constructed of combustible materials.
Your Life ... Step 5: Prepare Electrical 5, Prepare Electrical Connection Ranges are dual rated for use on either 120/240 VAC or 120/208 VAC. See chart below for power ratings and circuit breaker sizes based on the supply voltage for each model, MODEL: HDS VOLTS HZ A.C. 6O 120/240 6O 120/208 I _ RATING KW 6.5 4.8 CIRCUIT BREAKER 30 AMPS 30 AMPS Install Connection Strain Relief Place strain relief in knockout below terminal block (See Figure 4).
Step 6: Installation = Connect ,,, Electric Our Three Wire Connection The Four Wire Connection is preferred, but where local codes and ordinances permit grounding through neutral and/or conversion to four wire is impractical, unit may be connected to the power supply via a three wire connection. 1. Disconnect electrical power at breaker box. 2. Remove the terminal block cover to expose the terminal block (See Figure A). 3. Remove top nut, star washer, and round washer from each post.
Your Life ... Step 7: Installation = Connect Gas Supply Test for Gas Leaks Leak testing is to be conducted by the installer according to the instructions given in this section.
,,, Step 8: Test the 8A. Test Electric Ignition 8B.
BSH reserves products Appliances which the right are to change transported Corporation, 555! specifications from the McFadden or design United States Avenue, For the most up to date critical installation without for Huntington dimensions notice, use in Canada, Beach, Some Check models with are certified your local distributor BBH is not or dealer, responsible for BSH Home CA 92649, by fax, use your fax handset and call 702/833-3600, Use code #8030, BOSCH 5551 McFadden Ave