Installation Guide

17
Four-wire range cord connection (recommended
method)
1. Disconnect the electrical power at the breaker box.
Remove the terminal block cover to expose the
terminal block.
2. Remove the metal plate. Rotate it 180° to have the
lager hole for the power supply cable and mount it
again.
3. Insert the power supply cable into the terminal block
through the bottom hole.
4. Remove the grounding strap from the center post on
the terminal block. Therefore remove the hexagonal
nut of the neutral pin. Remove the fork type connector
of the groundling link. Mount the hexagonal nut on the
neutral pin again. Remove the green hexagonal screw
and the ring connector from the grounding. The strap
will not be needed. Remove it from the unit.
5. Attach the insulated grounding wire to the grounding
hole with the green grounding screw. Tighten the
green hexagonal nut firmly, but do not overtighten.
6. Insert the flat washer.
7. Attach the red wire to the left junction block terminal
using one of the hexagonal nuts.
8. Attach the white wire to the center junction block
terminal using one of the hexagonal nuts.
9. Attach the black wire to the right junction block
terminal using one of the hexagonal nuts.
10. Properly secure strain relief.
9 WARNING
WARNING
The strain relief provided with your range cord
must be installed correctly.
11. Tighten all connections securely and replace terminal
block cover.
Note: Do not plug in the range at this time.