Installation Instruction

en-us Installing the range into the cabinets
14
2. Pull out the warming drawer to fully open position.
3. Press down the right drawer release lever ⁠.
4. Lift up the left drawer release lever ⁠.
5. Firmly pull the drawer straight out ⁠.
6. Retract the cabinet rails while the drawer is removed.
7. Grasp both sides of the drawer and carefully remove
the drawer housing, pulling straight and level.
This step may require light to moderate force to com-
pletely remove drawer.
7.5 Reinstalling the warming drawer to the
drawer housing
Requirement:The slides mounted to each side of the
housing wall have two moving components, an inner rail
and a ball bearing carrier which need to be in the proper
orientation for accurate installation and alignment. There is
also a visible locking mechanism located at the rear of
each slide.
1. Slide the inner rail to the locked position by pushing it
toward the rear of the housing until it locks in place.
Note:A moderate force pushing on the black plastic
ball carrier locking mechanism is required to activate
the lock. When the drawer is installed, the locking
mechanism prevents the drawer from springing back to
the open position.
2. Position the warming drawer in front of the drawer hous-
ing. Align the rail with the plastic rail tip to the ball car-
rier slide.