Technical data

Commissioning | 15

8 716 473 216 (2014/09)Gaz 6000 W

6.3.2 Replacing the power cable

Use only original power cable.

The control unit must be opened to connect the power cable.

▶ Disconnect the ignition cable.

▶ Remove cover.

▶ Remove old cable.

▶ Plug new cable connector on the conductor board.

▶ Plug strain relief to the case.

▶ Mount cover.

▶ Connect ignation cable.

Fig. 17

7 Commissioning

Fig. 18

[1] Drain hose

[2] Heating return valve (accessory)

[3] Cold water valve (accessory)

[4] Gas valve (closed) (accessory)

[5] Heating flow valve (accessory)

[6] Automatic air vent valve

[7] Standby key

[8] Display

[9] “Back” key (= exit service function/submenu without saving)

[10] + key

[11] OK button (= confirm selection, save value)

[12] – key (mode)

[13] Pressure gauge

[14] System top-up fixture

[15] Test point

[16] Cold water supply

6 720 806 640-17.1O

8 716 473 216-08.2O

mode

reset

press 5s

7 8