Installation Guide
Table Of Contents
- Free standing cooker
- en-us
- Table of contents
- 1 IMPORTANT SAFETY INSTRUCTIONS
- 2 Before you begin
- 3 Installation procedure
- 3.1 How to remove the oven door
- 3.2 Fitting the rear vent trim
- 3.3 Fitting the adjustable feet
- 3.4 Install appliance
- 3.5 Installing the anti-tip bracket
- 3.6 Connect electrical supply
- 3.7 Preparation for power connection
- 3.8 Four-wire range cord connection (recommended method)
- 3.9 Connecting the three-wire range cord (alternate method)
- 3.10 Connecting the four-wire flexible conduit
- 3.11 Connecting the three-wire flexible conduit
- 3.12 Testing the operation
- 4 Customer Service
- 5 Wiring diagrams
- fr-ca
- Table des matières
- 1 IMPORTANTES CONSIGNES DE SÉCURITÉ
- 1.1 Définitions des termes de sécurité
- 1.2 Informations générales
- 1.3 Consignes générales de sécurité
- 1.4 Manipulation sécuritaire des appareils
- 1.5 Lieu d'installation
- 1.6 Codes et normes de sécurité
- 1.7 Sécurité électrique
- 1.8 Mises en garde conformément à la proposition 65 de l'État de Californie
- 1.9 Transport
- 2 Avant de commencer
- 3 Procédure d’installation
- 3.1 Comment retirer la porte du four
- 3.2 Ajustement de la garniture de ventilation arrière
- 3.3 Montage des pieds réglables
- 3.4 Installer l'appareil
- 3.5 Montage de la console anti-basculement
- 3.6 Raccordement à l'alimentation électrique
- 3.7 Préparation à la connexion électrique
- 3.8 Liaison par cordon à quatre fils de la cuisinière (méthode recommandée)
- 3.9 Raccordement du cordon à trois fils de la cuisinière (autre méthode)
- 3.10 Raccordement du conduit électrique flexible à quatre fils
- 3.11 Raccordement du conduit électrique flexible à trois fils
- 3.12 Opération d’essai
- 4 Service à la clientèle
- 5 Schémas de branchement
en-us Before you begin
8
36" Ranges
2.6 Cabinet requirements
X Grounded Outlet
The distances that must be maintained when installing
the range shall be:
A min. 7" (178mm)
B min. 18" (457mm)
C min. 30" (762mm) clearance between the top of
the cooking surface and the bottom of the un-
protected wood or metal cabinet
D 30": min. 30" (762mm)
36": min. 36" (914mm)
E min. 25" (635mm)
F max. 13" (330mm)
G 30": min. 30" (762mm)
36": min. 36" (914mm)
Zero clearance between adjacent combustible
construction below the countertop surface and
sides of the appliance
H 35⅜" - 36⅝" (898 - 930mm)
I max. 11" (279mm)
J max. 7" (178mm)
From the cooking surface to side materials: no clearance
is required from unit walls to adjacent vertical combustible
walls on rear, right or left.