Installation Instructions

English 5
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
For appliances equipped with a cord and plug, do not
cut or remove the ground prong. It must be plugged into
a matching grounding type receptacle to avoid electrical
shock. If there is any doubt as to whether the wall recep-
tacle is properly grounded, the customer should have it
checked by a qualied electrician.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
Installer – show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
Be sure your appliance is properly installed and grounded
by a qualied technician. Installation, electrical connec-
tions and grounding must comply with all applicable
codes.
Microwave Safety
PRECAUTIONS TO BE OBSERVED BEFORE AND
DURING SERVICING TO AVOID POSSIBLE EXPOSURE
TO EXCESSIVE MICROWAVE ENERGY
• Do not operate or allow the oven to be operated with
the door open.
• Make the following safety checks on all ovens to be
serviced before activating the magnetron or other
microwave source, and make repairs as necessary:
1. Interlock operation
2. Proper door closing
3. Seal and sealing surfaces (arcing, wear, and other
damage)
4. Damage to or loosening of hinges and latches
5. Evidence of dropping or abuse
• Before turning on microwave power for any service test
or inspection within the microwave generating compart-
ments, check the magnetron, wave guide or transmis-
sion line, and cavity for proper alignment, integrity, and
connection.
• Any defective or misadjusted components in the inter-
lock, monitor, door seal, and microwave generation and
transmission systems shall be repaired, replaced, or
adjusted by procedures described in this manual before
the oven is released to the owner.
• A microwave leakage check to verify compliance with
the Federal Performance Standard should be per-
formed on each oven prior to release to the owner.
Related Equipment Safety
Remove all tape and packaging before using the
appliance. Destroy the packaging after unpacking the
appliance. Never allow children to play with packaging
material.
Never modify or alter the construction of the appliance.
For example, do not remove leveling legs, panels, wire
covers or anti-tip brackets/screws.
WARNING
To reduce the risk of re, use only metal ductwork.
CAUTION
For general ventilating use only. Do not use to
exhaust hazardous or explosive materials and
vapors.