Installation Guide
English 6
Unpacking Your Drawer Microwave
• Remove all packing materials from inside the Drawer
Microwave. DO NOT REMOVE THE WAVEGUIDE
COVER. The Waveguide Cover is attached to the
ceiling of the Drawer Microwave. The mica cover is dark
grey and cardboard-like, and measures approximately
9" x 10". The Waveguide Cover must remain in place
at all times. Never allow children to play with packaging
material.
• Check the drawer for any damage, such as a
misaligned or bent drawer, damaged drawer seals or
sealing surfaces, broken or loose drawer guides or
dents inside the cavity or on the front of the drawer.
If there is any damage, do not operate the Drawer
Microwave. Contact your dealer or Bosch Customer
Support.
Figure 1
Waveguide
Cover
Sealing
Surface
Oven
Cavity
Sealing
Surface
Important Notes to the Installer
• Unit is heavy and requires at least two people or proper
equipment to move.
• Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
• Read and understand the contents of this Installation
Manual before installing the Drawer Microwave.
• Remove all packing material before connecting the
electrical supply.
• It is the responsibility of the owner and the installer
to assure compliance with all applicable safety codes
and standards. See UL 923, The Microwave Cooking
Appliances.
• The unit may be installed using a standard or ush
(inset) installation per the following instructions.
Important Notes to the Consumer
Keep this manual with your Use and Care Manual for
future reference.
• As when using any microwave oven generating heat,
there are certain safety precautions you should follow.
These are listed in the Use and Care Manual. Read all
and follow carefully.
WARNING
The appliance should only be installed by a licensed
electrician or a qualied technician.