Installation Instruction

en Appliance door
36
3.
Clean the rail.
→"Cleaning products", Page31
24.2 Fitting the retainers
The retainers may fall out when you detach the rails.
Note:
The retainers at the front differ from those at the rear.
1.
Hook the front retainers with the hook into the round
hole at the top and set them at a slight angle ⁠.
2.
Hook the front retainers in at the bottom and
straighten them ⁠.
3.
Hook the rear retainers with the hook into the top
hole and push them into the bottom hole ⁠.
24.3 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both pull-out rails, ensure that you can pull them
forwards and out.
1.
Hook the rear shelf support into the retainers at the
top and bottom and pull it forwards ⁠.
2.
Hook in the rail at the front and press it down .
25 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
25.1 Removing the door cover
The stainless steel inlay in the door cover may discol-
our. Remove the door cover in order to clean it and the
stainless steel inlay, or to remove the door panes.
1.
Open the appliance door slightly.
2.
Press down on the left- and right-hand sides of the
door cover.
3.
Remove the door cover and carefully close the ap-
pliance door.