Installation Instruction
Table Of Contents
- Oven
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Familiarising yourself with your appliance
- 5 Operating modes
- 6 Accessories
- 7 Before using for the first time
- 8 Basic operation
- 9 Rapid heating
- 10 Time-setting options
- 11 Steam
- 12 Microwave
- 13 Meat probe
- 14 Assist
- 15 Childproof lock
- 16 Sabbath mode
- 17 Basic settings
- 18 Home Connect
- 19 Cleaning and servicing
- 20 Cleaning function Pyrolytic self-cleaning
- 21 Cleaning assistance
- 22 Descaling
- 23 Drying
- 24 Rails
- 25 Appliance door
- 26 Troubleshooting
- 27 Disposal
- 28 Customer Service
- 29 How it works
- 29.1 General cooking tips
- 29.2 Baking tips
- 29.3 Roasting, braising and grilling tips
- 29.4 Microwave cooking
- 29.5 Cooking frozen products
- 29.6 Cooking ready meals
- 29.7 List of foods
- 29.8 Special cooking methods and other applications
- 29.9 Test dishes
- 30 Installation instructions
Installation instructions en
55
isolating switch must be integrated into the perman-
ent electrical installation in accordance with the in-
stallation regulations.
Electrically connecting an appliance without a
protective contact plug
Note:Only a licensed professional may connect the ap-
pliance. Damage caused by incorrect connection is not
covered under the warranty.
An all-pole isolating switch must be integrated into the
permanent electrical installation according to the install-
ation regulations.
1.
Identify the phase and neutral conductors in the
socket.
The appliance may be damaged if it is not connec-
ted correctly.
2.
Connect the hob in accordance with the connection
diagram.
See the rating plate for the voltage.
3.
Connect the wires of the mains power cable accord-
ing to the colour coding:
‒ Green/yellow = Protective conductor
‒ Blue = Neutral conductor
‒ Brown = Phase (external conductor)
30.8 Installing the appliance
1.
Slide the appliance in fully and centre it.
2.
Screw the appliance into place.
3.
For handleless kitchens with vertical bar handle
strips:
‒ Attach a suitable filling piece in order to cover
any sharp edges and to guarantee a safe install-
ation.
‒ Pre-drill aluminium profiles to establish a screw
connection .
‒ Secure the appliance using a suitable screw .
Note:The gap between the worktop and the appliance
must not be closed by additional battens.
Thermal insulation strips must not be fitted to the side
panels of the surround unit.
30.9 Removing the appliance
1.
Disconnect the appliance from the power supply.
2.
Undo the fastening screws.
3.
Lift the appliance slightly and pull it out completely.