Installation Instruction

12
Preparing the units
Fitted units must be heat-resistant up to 194° F (90 °C).
The stability of the fitted unit must also be assured after
the cut-out work.
Make the cut-out according to the installation sketch.
After the cutting out work is complete, remove the
shavings.
Notes
▯ Be aware of the clearance between the partition floor
and the lower edge of the fitted unit; see drawing.
▯ Use the included template to make the holes and the
cut-outs.
1. Attach the template to the lower side of the partition
floor. Drill holes.
2. Make cut-out for the exhaust air pipe:
Exhaust air opening above the fitted unit:
Exhaust air opening behind the fitted unit:
èç¼ʀɿ
PP
[

çɾʃ
PP





