Instruction manual

en Trouble shooting
24
Fitting
1. Hold the top glass panel firmly by the sides and slide
it in towards the back at an angle. The panel must
be inserted into the openings on the lower side. The
smooth surface must face outwards, while the
roughened side must be on the inside. (Fig. A).
2. Place the cover on the top of the oven door and
press in place. Make sure that the grooves along the
sides lock into position.
3. Refitting the oven door See the section Refitting the
oven door
.
Do not use the oven again until the panels have been
correctly fitted.
Upper glass cover
Before opening the top cover, remove any spills with a
cloth.
Use glass cleaner if possible.
For cleaning, remove the top cover. To do this, hold the
cover securely on both sides with both hands and pull it
upwards.
If the cover hinges become loose, note the letters
marked on them. The hinge with the letter R must be
fitted on the right, and the hinge with the letter L must
be fitted on the left.
After cleaning, re-assemble the top cover following the
same procedure in reverse order.
Only close the top cover once the burners have cooled
down.
3Trouble shooting
Tr ou bl e s hoot i ng If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Malfunction table
If your meal is not successful, please refer to section .
We have tested the recipe for you in our cooking studio
. Here,
you will find useful cooking tips and tricks for cooking,
baking and roasting.
:Warning – Risk of electric shock!
Repairs that are not carried out properly are dangerous.
Repairs must only be performed by one of our after-
sales service technicians.
$
Malfunction Possible cause Remedy/information
The oven does
not work.
The circuit
breaker is defec-
tive.
Look in the fuse box to see if
the circuit breaker is defective.
Power cut. Check whether the kitchen light
and other kitchen appliances
are working.
Oven not hot. Dust on the con-
tacts.
Turn the control knobs several
times to the left and right.
The timer is at the
0 position.
Turn the timer to the OFF posi-
tion.
The burner does
not ignite.
Power has failed
or ignition plugs
are damp.
Light the gas burner with a gas
lighter or a match.