Instruction manual

en Trouble shooting
28
:Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Fitting
1. Hold the top glass panel firmly by the sides and slide
it in towards the back at an angle. The panel must
be inserted into the openings on the lower side. The
smooth surface must face outwards, while the
roughened side must be on the inside. (Fig. A).
2. Place the cover on the top of the oven door and
press in place. Make sure that the grooves along the
sides lock into position.
3. Refitting the oven door See the section Refitting the
oven door
.
Do not use the oven again until the panels have been
correctly fitted.
Upper glass cover
Before opening the top cover, remove any spills with a
cloth.
Use glass cleaner if possible.
For cleaning, remove the top cover. To do this, hold the
cover securely on both sides with both hands and pull it
upwards.
If the cover hinges become loose, note the letters
marked on them. The hinge with the letter R must be
fitted on the right, and the hinge with the letter L must
be fitted on the left.
After cleaning, re-assemble the top cover following the
same procedure in reverse order.
Only close the top cover once the burners have cooled
down.
3Trouble shooting
Tr ou bl e s hoot i ng If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 30
--------
:Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Error messages on the display
If an error message with "“" appears on the display,
e.g. “‹†-„ƒ, touch the v button. This will reset the
error message. Reset the time, if necessary.
If the fault was a one-off, you can continue to use your
appliance as normal. If the error message appears
again, call our after-sales service and quote the exact
error message and the E no. of your appliance.
~ "Customer service" on page 29
$
Fault Possible
cause
Notes/remedy
The appliance is
not working.
Defective cir-
cuit breaker.
Check the circuit breaker in the
fuse box.
Power failure Check whether the kitchen light
or other kitchen appliances are
working.
The time is flash-
ing on the display.
Power failure. Reset the time.
The settings on
the appliance
cannot be config-
ured. A key sym-
bol has lit up on
the display or
†‘”“.
The child-
proof lock is
activated.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
The gas burner
does not ignite.
Power cut or
damp ignition
plugs.
Light the gas burner with a gas
lighter or a match.