Operation Manual

English | 39
Bosch Power Tools F 016 L81 115 | (7.10.14)
Note: Keep the PIN code secret from third parties.
If you have lost your personal PIN code, you will have to return
the Indego and its docking station to a Bosch Service Center
to be unlocked. Please contact your dealer or Bosch (see “Af-
ter-sales Service and Application Service”).
Select the “hh:mm”, “dd/mm/yy” and “Format: 12 hr” input
positions with the left/right cursors, adjust the values with the
up/down cursors and confirm with “Save” or select “Back” to
return to the first “PIN code” screen.
Press “Follow Wire” to map the garden.
(Select “Back” to return to the “Date & Time” screen.)
Note: If the Indicator on the docking station flashes at this
point the perimeter wire is broken, too long (above 450 m) or
too short (below 20 m).
The following screen indicates the initial follow of perimeter
wire:
The blades do not rotate when the machine follows the wire
for the first time.
Note: Whilst mapping the Indego will follow the wire around
the edge of the lawn area. Where the wire is run to and from
an obstacle within 1 cm as described the Indego will not de-
tect the wire but continue along the wire around the perimeter
of the lawn. (see figure 7)
Mapping is complete when the machine reaches the back of
the docking station.
If the machine hasn’t reached the back of the docking station
press “Obstacle” and observe information indicated on the
screen to complete installation.
If the machine has reached the back of the docking station
press “Docking Station”.
Date & Time
hh:mm/yy
dd/mm
Format: 12 hr
Back Save
Installation
Please press Follow Wire to
complete installation process
Back
Follow
Wire
Installation
Step Back
Machine is about to start. Wire
being followed...
Mower Status
Mapping the garden ...
Back
Message
Is this the back of the docking
station or an obstacle? If this is
an obstacle, remove it and ma-
chine will continue mapping.
Obstacle
Docking
Station
OBJ_BUCH-1573-007.book Page 39 Tuesday, October 7, 2014 12:49 PM