WASHER-DRYER en Instruction Manual and Installation Instructions V6540X1GB
Your new washer-dryer You have chosen a Neff washer-dryer. Please take a few minutes to read and become familiar with the advantages of your washing machine. To meet the high quality demands required by Neff, every washerdryer that leaves our factory is carefully checked to ensure that it functions correctly and is in perfect condition. For more information on our products, accessories, replacement parts and services, see our website www.neff-international.com or contact our after-sales service centres.
Contents Operating instructions Installation instructions Appendix General safety information ......................................................... 4 Environmental protection/economy tips .................................. 6 Your new washer-dryer ............................................................... 7 Before washing for the first time ................................................ 9 Preparing and sorting the laundry .............................................
General safety information Intended use – For private domestic use only. – The washer dryer is suitable for machine washable textiles and hand washable wool and for drying certain types of textiles according to care instructions. – The appliance is suitable for operation with cold mains water and commercially available detergents and care products which are suitable for use in a washer dryer.
Safety for children Warning Danger of death! If children play with the washer dryer, they may get into lifethreatening situations or injure themselves. – Do not leave children unattended near the washer dryer. – Do not let children play with the washer dryer. Warning Danger of death! Children may lock themselves in appliances, putting their lives at risk. For appliances that have reached the end of their service life: – Disconnect the mains plug.
Environmental protection/economy tips – Separate out the various waste materials of the packaging and take them to the nearest collection point. – Always fill the washer-dryer with the maximum load for the relevant programme. – Wash normally soiled laundry without a prewash. – Instead of Cottons 90 °C, select the Cottons Eco 60 °C programme. This gives comparable results, but uses less energy. – Measure the detergent according to the manufacturer's instructions and in line with the local water hardness.
Your new washer-dryer Description of the washer-dryer The washer-dryer can be used in 3 ways –> page 17: – washing only – drying only – successive washing and drying. The successive wash-dry programme automatically shifts from the wash cycle to the dry cycle without further intervention. Drying is achieved using the condensation principle. The condensate that is produced during drying runs via the Drain hose into the Drain tank.
Control panel Display panel Shows the settings that have been selected (e.g. spin speed, drying time), the progress of the current programme and the programme status. Programme progress T N ' Indicator lamp Indicates the settings that have been selected for: – Temperature: Ž - 90°C. – Spin speed: $ - 1400 rpm. – Options/signal. B ‘ Drying options P e e: 5 Auxiliary displays 2 % E l kg Indicator lamp Pre-wash, Main wash, Rinse, Final spin, Drying.
Before washing for the first time The washer-dryer was tested before leaving the factory. To remove any water that may be left over from the test, do not load any laundry the first time that you run a wash programme. Make sure that the transport safety bolts on the rear of the washerdryer have been removed –> page 26. Do not load any laundry. Close the door. Turn on the tap. Pull out the detergent drawer. Add ½ a measuring cup of detergent to compartment II –> page 11.
Sorting laundry for drying Sorting laundry according to the information on the care labels Only dry laundry that is labelled "suitable for tumble-drying" or which has the following care symbols: Care label Type of laundry a Dry at normal temperature. ` Dry at low temperature (delicate drying). Do not wash the following fabrics in the washer-dryer: – Do not machine dry laundry with the b care symbol. – Airtight fabrics (e.g. rubber-coated fabrics).
Detergents and Care Products The detergent drawer is divided into three compartments Detergent drawer Compartment I : detergent for pre-wash. Compartment II : detergent for main wash, Compartment i : Liquid additives, such as starch or fabric softener. Additives are automatically dispensed during the final rinse cycle. I II – Do not exceed the maximum capacity, otherwise compartment i may be emptied too early. – Dilute viscous additives with water to prevent blockages.
Normally soiled laundry Measuring washing powder Set the programme. Do not select ! (Pre-wash) –> page 15. Add all the detergent, according to the manufacturer's instructions, to compartment II of the detergent drawer. Heavily soiled laundry Set the programme. Select ! (Pre-wash) –> page 15. Add 1/4 of the recommended amount of detergent to compartment I of the detergent drawer and 3/4 of the detergent to compartment II. Only use liquid detergent for the main wash cycle with no prewash.
Programmes The programme selector is used to set the washing and drying programmes. Programme selector i Washing programmes* *depends on the model The time remaining until the end of the programme and the Beladungsmenge (Load) are shown on the display panel. Cottons Suitable for hard-wearing fabrics, heat-resistant fabrics made from cotton or linen. – Coloureds up to 60 °C. – Whites 60 °C to 90 °C.
Washing programmes* * depends on the model Sensitive For washing fabrics with increased hygiene requirements or those that will be used by allergy sufferers. The temperature remains constant during the washing process. More intensive rinsing with increased water level. For hard-wearing and easy-care fabrics made from cotton or linen. Night Wash Particularly quiet wash programme with a reduced final spin. Sleep mode.
Washing and drying options Temp. button The temperature can be adjusted individually for each programme. To adjust it, press the Temp. button repeatedly until the required temperature is displayed. Spin speed button The spin speed can be individually adjusted for each programme. To set the spin speed, press the Spin button repeatedly until the required spin speed is displayed. Rinse hold $ (Rinse hold) deactivates the spin function. The laundry remains in the rinsing water.
The drying programmes –> page 14 can be individually adapted by selecting the drying options. – Press the Dry button repeatedly until the required drying option is shown on the display panel. – To deactivate, press the Dry button repeatedly until is shown on the display. Dry button Drying options (symbols on the display panel) 0 Time-controlled drying The drying time can be set to between 2:40 and 0:00 by repeatedly pressing the Dry button. P Iron-damp The residual moisture in the washing is increased.
Washing and drying Turn the programme selector to the desired programme, e.g. Cottons 60°C. – The display panel alternately shows 2 (Remaining time) and the recommended load in kg. The % symbol flashes. Washing only i If necessary, adjust the temperature and the spin speed and select any options for your individualised programme, –> page 15. – The Dry function must not be activated. Load the laundry –> page 10. – Observe the maximum load, Programme table –> page 30. Press the Start/Pause button.
The washing and drying programmes are ended automatically. appears on the display panel. End of the programme Turn the programme selector to Off. Remove the washing from the drum. Leave the door open to allow the inside of the washer-dryer to dry out. Turn off the tap (not necessary on models with Aqua-Stop).
Cleaning and care Safety information Risk of electric shock You must disconnect the appliance from the mains first. Never clean the washer-dryer with a water jet. Risk of explosion. Never clean the washer-dryer with solvents. Risk of scalding Hot washing water must be cooled before Draining. Housing and control panel Drum Wipe with a soft, damp cloth. Remove detergent and cleaning agent residue immediately. Do not clean with a jet of water. Remove any foreign bodies from the drum and rubber seals.
Drain pump Set the programme selector to Off. Use a screwdriver to release the lock pins. Tip the kick panel and pull upwards to remove. Draining the water Take the Drain hose out of the retainer. Remove the plug from the Drain hose and release the washing water. – The container for the Drained water may have to be emptied several times. – When no more water runs out, replace the plug. Place the Drain hose into the retainer. Cleaning the Drain pump Unscrew the pump cover.
What to do if... Risk of electric shock. Repairs must only be carried out by customer services or authorised technicians. If repairs are needed, or if you cannot rectify a fault yourself with the help of the following table: Set the programme selector to Off. Disconnect the washer-dryer from the power supply. Turn off the tap. Call the after-sales service –> page 24. Fault code The door is not properly closed. Close the door. The water control system has been activated.
The mains plug is not correctly plugged in. Plug in the mains plug correctly. The door is not properly closed. Close the door. The tap is not turned on. Turn on the tap. The filter in the water supply hose is blocked. Clean the filter in the water supply hose –> page 20. The water supply hose is pinched or kinked. Check the water inlet hose. The washer-dryer is not correctly levelled. Level the washer-dryer –> page 27. The transport safety bolts have not been removed.
Drying result not satisfactory. The laundry clings to the sides of the drum after being spun. Loosen up the laundry by hand; start the drying programme –> page 17. Closed tap Turn on the tap. Selected drying time too short. Select the drying time according to the Load. Maximum or minimum load not taken into account –> page 30 Once the programme has ended: adjust the load quantity, select a suitable drying programme and restart.
After-sales service Before you call the after-sales service, please check whether you can correct the fault yourself –> page 21. You will be charged if a technician is called out, even during the warranty period. You can find information about your nearest after-sales service here or in the After-sales service directory (depending on the model). Please give the after-sales service the product number (E-Nr.) and production number (FD) of the appliance. Enter the number of your appliance here.
Installation instructions Safety information The washer-dryer is very heavy. Take care when lifting it. Do not operate the washer-dryer if it has any visible damage. If you are in any doubt, please consult our after-sales service or your retailer. Do not install the washer-dryer outdoors or in areas exposed to frost. Frozen hoses can crack or burst. As a result, the washer-dryer could be damaged. Do not stand the washer-dryer upside down or on its side. Do not lift the washer-dryer by protruding parts (e.
Removing the transport safety bolts Unscrew all screws using the spanner supplied. Remove all transport safety bolts completely and take the mains cable out of the retainers. – Before using the appliance for the first time, you must make sure that all transport safety bolts have been removed and kept safe for any subsequent transport. Insert the protective covers.
Intense noise, vibrations and “wandering” may be the result of incorrect levelling. Levelling – All four appliance feet must stand firmly on the ground. – The washer-dryer must not wobble. – Check the levelness of the washer-dryer with a spirit level and correct if necessary. – The washer-dryer must not rest against the sides of the installation recess. – The lock nuts of the front appliance feet must be screwed tightly against the housing. . Hose and cable lengths Left-hand connection approx.
Water connection To prevent leaks or water damage, you must observe the instructions in this section. If in doubt, have a technician connect the appliance. The water supply and Drain hoses can be routed to the left of right, depending on installation conditions. Do not use a used inlet hose. Only use the inlet hose supplied or one which was purchased from an authorised specialist retailer.
Electrical connection The washer-dryer must only be connected to an alternating current supply via a properly installed earthed socket. If a residual current circuit breaker is used, only use a type which displays this symbol: ‚. Only this symbol guarantees compliance with the currently applicable regulations. The mains voltage must match the voltage specifications on the washerdryer (rating plate). The connected load and fuse required are shown on the rating plate.
For delicate, washable fabrics, e.g. made of silk, satin, synthetic fibres or blended fabrics (e.g. curtains). Suitable for hand or machine-washable fabrics made from wool or a wool blend. cold-30-40-60 cold-30-40 cold-30-40 cold-30-40 Easy-Care Mix Delicates/Silk : Fabrics made from microfibre.
Consumption rates Washing Programme Load Cottons 30 °C Cottons 40 °C 7 kg Cottons 60 °C X Intensive* Mix 30 °C Easy-Care 40 °C 3.5 kg Delicates/Silk 30 °C : Wool (cold) 2 kg : Wool 30 °C Cottons 60 °C X Intensive, Intensive Dry Š (2 cycles)** 7 kg/4+3 kg Energy*** Water*** Programme duration*** 0.44 kWh 62 l 1:51 h 0.83 kWh 62 l 1:51 h 1.27 kWh 52 l 2:45 h 0.30 kWh 44 l 0:49 h 0.62 kWh 45 l 1:43 h 0.20 kWh 49 l 0:36 h 0.10 kWh 49 l 0:47 h 0.20 kWh 49 l 0:47 h 5.
Index -Display panel .................. 8 -Options ..........................16 I -Synthetics ......................10 Care information -Woollens ........................10 Included with the appliance -Drying .............................10 Drying programmes ...........14 .................................................25 -Washing ........................... 9 Installation surface .............25 Care product .......................11 Iron-damp Childproof lock ....................18 -Drying options .......
-Pausing ..........................16 -Progress ........................16 W Programme selector ..... 8, 13 Washer-dryer Programme start -Positioning and levelling -Display panel .................. 8 ..........................................26 Washing ................................17 and drying ......................17 -Washing options ..........15 R Washing options Remedial action ..................21 -Indicator lamp ................ 8 Rinse Washing programmes 13, 14 -Display panel ..................
V6540X1EU 06.
