Use and Care Manual
!-:>1+-
:->-6<1>- 5)16<-6)6+-
8-:.7:5-, *A=6)=<07:1B-,
8-:;766-4 5)A :-;=4< 16 51;84)+16/7.
16<-:6)4 ?1:-; )6, +75876-6<; ?01+0
+7=4, +)=;- ;-:17=; 0)B):, We
recommend that all tool service be performed
by a Bosch Factory Service Center or Autho -
rized Bosch Service Station.
"# "
Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.
#!!
The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brush es be examined.
Only genuine Bosch replace ment brushes
specially designed for your tool should be
used.
!
Bearings which become noisy (due to heavy
load or very abrasive material cut ting) should
be replaced at once to avoid overheating or
motor failure.
!
WARNING
)16<-6)6+-
#""#
7<16+4=,-,;74,;-8):)<-4A
The JA1010 attachment is available at an
extra cost. It is used for fast and accurate
straight and circle cutting (Fig. 10).
#""
1. Insert bar of guide through lock knob clamp,
then through the slots provided in foot, from
either side of foot with the edge guide facing
UP (Fig. 9).
2. Hook lock knob clamp onto edge of
footplate, adjust fence to desired width, and
securely tighten lock knob clamp (Fig. 9).
#""
1. Before attaching the guide, draw a circle
and predrill a 3/16” (5 mm) center hole in
workpiece.
2. Drill or plunge cut near the circles edge,
turn saw off and disconnect the plug from
power source.
3. Attach guide to saw with edge guide facing
down as shown (Fig. 10).
4. Remove guide pin from end of guide, push
pin through hole provided in guide, then into
center hole of workpiece.
5. Measure the distance from the selected
hole to the blade to be equal to the circle
radius.
6. Hook lock knob clamp onto edge of
footplate, adjust fence to desired width, and
securely tighten lock knob clamp (Fig. 10).
7. Insert plug into power source, hold the saw
firmly, squeeze trigger and slowly push the
saw forward. To make a hole, cut from inside
the circle; To make wheels or discs, cut from
the outside.
Cutting Tip: Cut slowly so the blade will stay
straight in the cut. Place small wedges in the
cut as shown in Fig. 10, to keep the inner
circle from spreading when near the end of the
cut.
-12-
FIG. 10
WEDGE
EDGE
GUIDE UP
LOCK
KNOB
CLAMP
FIG. 9
EDGE GUIDE DOWN
BM 2609932805 12-11:BM 2609932805 12-11.qxp 12/6/11 8:43 AM Page 12