Operating/installations instructions

en
20
Proceed as follows:
1. Switch off the appliance before cleaning.
2. Pull out the mains plug or switch off the fuse.
3. Take out the frozen food and store in a cool place.
Place the ice pack (if supplied) on the food.
4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth, lukewarm water
and a little pH-neutral washing-up liquid.The rinsing
water must not run into the light.
6. Remove the water tank of the fresh-mist system and
clean.
Notes
■ Over time a thin layer of limescale may form on
the water tank. Remove this layer with a soft
brush.
■ Condensation may form in the vegetable container
and in the opening of the fresh-mist system
depending on the setting selected.
Remove any condensation with a dry cloth.
7. Wipe the door seal only with clean water and then
wipe dry thoroughly.
8. After cleaning reconnect and switch the appliance
back on.
9. Put the frozen food back in the appliance.
Interior fittings
To clean the equipment, all variable parts of
the appliance can be taken out (see chapter Variable
interior design).
Note
To take out and clean the containers, open the doors
fully beyond 90°.
Removing the container
Pull out container all the way, lift to detach it from
the holder and take out.
To insert the container, place on the telescopic rails
and push into the appliance. Attach the container by
pressing it down.
Removing vegetable container with humidity control
1. Pull out vegetable container.
2. Take out the glass shelf.
3. Remove the moisture cover.
Replacing vegetable container with humidity control
1. First replace the moisture cover.
2. Insert the glass shelf.
3. Slide the vegetable container back in.
Removing the water tank of the fresh-mist system
1. Take out the water tank and remove the cover.
2. Empty out the water.
Light (LED)
Your appliance features a maintenance-free LED light.
These lights may be repaired by customer service
or authorised technicians only.