Refrigerator KIR51.. / KIR41.. / KIR31.. / KFR31.. / KIR21.. / KFR21..
en Table of Contents Safety and warning information ............ Information concerning disposal .......... Scope of delivery .................................... Room temperature, ventilation and cavity depth ...................................... Installation location ................................. Connecting the appliance ..................... Getting to know your appliance ........... Switching on the appliance ................... Setting the temperature ......................... Alarm function .....
en enTable of ContentsenI struction for Use Safety and warning information Before you switch ON the appliance Please read the operating and installation instructions carefully! They contain important information on how to install, use and maintain the appliance. The manufacturer is not liable if you fail to comply with the instructions and warnings. Retain all documents for subsequent use or for the next owner.
en ■ ■ ■ ■ Bottles which contain a high percentage of alcohol must be sealed and stored in an upright position. Keep plastic parts and the door seal free of oil and grease. Otherwise, parts and door seal will become porous. Never cover or block the ventilation openings for the appliance. People (childern incl.) who have limited physical, sensory or mental abilities or inadequate knowledge must not use this appliance unless they are supervised or given meticulous instructions.
en m Warning Redundant appliances 1. Pull out the mains plug. 2. Cut off the power cord and discard with the mains plug. 3. Do not take out the trays and receptacles: children are therefore prevented from climbing in! 4. Do not allow children to play with the appliance once it has spent its useful life. Danger of suffocation! Refrigerators contain refrigerant and gases in the insulation. Refrigerant and gases must be disposed of professionally.
en Cavity depth Electrical connection A cavity depth of 560 mm is recommended for the appliance. If the cavity depth is smaller – at least 550 mm – the energy consumption increases slightly. The socket must be near the appliance and also freely accessible following installation of the appliance. The appliance complies with the protection class I. Connect the appliance to 220-240 V/50 Hz alternating current via a correctly installed socket with protective conductor.
en Getting to know your appliance Controls Fig. " 1 2 3 Please fold out the illustrated last page. These operating instructions refer to several models. The features of the models may vary. The diagrams may differ. Fig. ! * Not all models.
en Operating tips ■ ■ ■ After the appliance has been switched on, it may take several hours until the set temperature has been reached. Do not put any food in the appliance beforehand. While the refrigeration unit is running, water droplets or hoarfrost may form at the rear panel of the refrigerator. This is due to functional reasons. It is not necessary to scrape off the frost or wipe off the water droplets. The rear panel defrosts automatically.
en ■ ■ To retain aroma, colour and freshness, pack or cover food well before placing in the appliance. This will prevent the transfer of flavours and the discolouration of plastic parts in the refrigerator compartment. Allow warm food and drinks to cool down before placing in the appliance. Note Avoid contact between food and rear panel. Otherwise the air circulation will be impaired. Food or packaging could freeze to the rear panel.
en Super cooling Super cooling sets the refrigerator temperature to the coldest temperature setting for approx. 15 hours. Then the appliance automatically switches to the temperature set prior to super cooling mode. Switch on super cooling mode, e.g. ■ ■ before placing large quantities of food in the refrigerator compartment. for the fast cooling of drinks. Switching on and off Fig. " Press “super” button 2. The button is lit when super cooling is switched on.
en Switching off and disconnecting the appliance Switching off the appliance Fig. " Press the On/Off button 1. Temperature display goes out, refrigerating unit switches off. Disconnecting the appliance If you do not use the appliance for a prolonged period: 1. Switch off the appliance. 2. Pull out mains plug or switch off fuse. 3. Clean the appliance. 4. Leave the appliance door open. Proceed as follows: 1. Before cleaning: Switch off the appliance. 2. Pull out the mains plug or switch off the fuse! 3.
en Take out shelves in the door Fig. + Lift shelves upwards and take out. Taking out glass shelf above vegetable container Fig. The glass shelf can be taken out and disassembled for cleaning. Note Before taking out the glass shelf, pull out vegetable container. Removing the container Fig. , Pull out the container all the way, lift at the front and remove. Light (LED) Your appliance features a maintenancefree LED light. These lights may be repaired by customer service or authorised technicians only.
en Operating noises Quite normal noises Droning Motors are running (e.g. refrigerating units, fan). Bubbling, humming or gurgling noises Refrigerant is flowing through the tubing. Clicking Motor, switches or solenoid valves are switching on/off. Preventing noises The appliance is not level Please align the appliance with a spirit level. If required, place something underneath. Containers or storage areas wobble or stick Please check the removable parts and re-insert them correctly if required.
en Fault Possible cause Remedial action The light does not function. The LED light is defective. See chapter “Light (LED)” section. Appliance was open too long. Light is switched off after approx. 10 min. When the appliance is closed and opened, the light is on again. Bottom of the refrigerator compartment is wet. The condensation channel or drainage hole are blocked. Clean the condensation channel and the drainage hole. See chapter Cleaning the appliance. Fig.
en Appliance self-test Customer service Your appliance features an automatic self-test program which shows you sources of faults which may be repaired by customer service only. Your local customer service can be found in the telephone directory or in the customer-service index. Please provide customer service with the appliance product number (E-Nr.) and production number (FD). These specifications can be found on the rating plate. Fig. .
! 5 " 4 3 2 1
# $ % & ' (
) * + , -
E - Nr FD - Nr .
9000825195 (9409) en
