LTC 8713 Series Instruction Manual EN Alarm Port Expanders
LTC 8713 Series | Instruction Manual | Important Safeguards EN | 2 Important Safeguards 1. Read, Follow, and Retain Instructions - All safety and operating instructions should be read and followed before operating the unit. Retain instructions for future reference. 2. Heed Warnings - Adhere to all warnings on the unit and in the operating instructions. 3. Attachments - Attachments not recommended by the product manufacturer should not be used, as they may cause hazards. 4.
EN | 3 LTC 8713 Series | Instruction Manual | Safety Precautions For Indoor Product 1. Water and Moisture - Do not use this unit near water - for example, in a wet basement, in an unprotected outdoor installation or in any area classified as a wet location. 2. Object and Liquid Entry - Never push objects of any kind into this unit through openings, as they may touch dangerous voltage points or short out parts that could result in a fire or electrical shock. Never spill liquid of any kind on the unit. 3.
EN | 4 LTC 8713 Series | Instruction Manual | FCC & ICES Information FCC & ICES INFORMATION Sicherheitshinweise (U.S.A. and Canadian Models Only) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
EN | 5 LTC 8713 Series | Instruction Manual | Safety Precautions Veiligheidsmaatregelen VOORZICHTIG: OPEN DE BEHUIZING OF DE ACHTERKANT VAN HET APPARAAT NIET. ZO VERMINDERT U HET RISICO OP ELEKTRISCHE SCHOKKEN. IN HET APPARAAT BEVINDEN ZICH GEEN ONDERDELEN DIE U ZELF KUNT REPAREREN. LAAT SERVICE EN ONDERHOUD UITVOEREN DOOR GEKWALIFICEERD PERSONEEL. Medidas de Segurança CUIDADO: PARA REDUZIR O RISCO DE CHOQUE ELÉCTRICO, NÃO RETIRE A TAMPA (OU A PARTE POSTERIOR).
LTC 8713 Series | Instruction Manual | Table of Contents EN | 6 Table of Contents Important Safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 FCC & ICES Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 1 UNPACKING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EN | 7 LTC 8713 Series | Instruction Manual | Unpacking 1 UNPACKING 3 Unpack carefully. This is electronic equipment and should be handled carefully. Check for the following items: • Verify the unit model number. • One (1) cable assembly with 9-pin D-sub connectors. If an item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If any items are missing, notify your Bosch Security Systems, Inc. Sales Representative or Customer Service.
EN | 8 LTC 8713 Series | Instruction Manual | Installation For each LTC 8540/00 unit used in an "alarm expanded configuration", one 12 VDC to 15 VDC, 5 W power supply1 (not included) is required. Each LTC 8540/00 unit is supplied with a single interface cable. This cable is used to connect a single LTC 8540/00 unit to one of the four expansion ports on the LTC 8713 Series Alarm Port Expander.
EN | 9 LTC 8713 Series | Instruction Manual | Installation 4.4 DIP Switch Settings The LTC 8713 Series Alarm Port Expander communicates with the Allegiant series main bay and the LTC 8540/00 Alarm Interface Unit via RS-232 communications. The LTC 8713 Series Alarm Port Expander contains internal DIP switches which can be used to set the communication parameters. The cover must be removed if the DIP switches need to be changed from their factory default settings. See Cover Removal.
EN | 10 LTC 8713 Series | Instruction Manual | Operation Allegiant series main bay and the LTC 8713 Series Alarm Port Expander. Make sure that the external power supply used to power the LTC 8540/00 Alarm Interface unit is not connected to a wall outlet. 2. Using the cable supplied with the LTC 8540/00 Alarm Interface Unit, connect one end of the cable to "PORT 1" on the rear of LTC 8713 Series Alarm Port Expander. Connect the other end of the cable to the "RS-232" port on the LTC 8540/00. 3.
EN | 11 LTC 8713 Series | Instruction Manual | Illustrations 6 ILLUSTRATIONS Figure 3 LTC 8713 Series - Front and Back Panels 5 4 9 3 8 2 7 1 1 6 6 S9502017AE Ports 1 Through 4 - Female 9-pin D-Sub Connector Pin 1 2 3 4 5 6 7 8 9 Function RTS Tx (Transmit) Chassis Ground Data Ground Data Ground Rx (Receive) CTS NC (No Connection) NC (No Connection) Bosch Security Systems | 02 February 2004 2 3 7 4 8 5 9 S9502018AE System Port - Male 9-pin D-Sub Connector Pin 1 2 3 4 5 6 7 8 9 Fu
EN | 12 LTC 8713 Series | Instruction Manual | Illustrations LT C 8600 Series or LTC 8800 Serie s Allegia nt Series Main Bay (Rear View) Ala rm Port Cable Supplied with LT C 8713 Series Ala rm Port Expanders LT C 8713 Serie s Ala rm Port Expanders (Rear View) Cables Supplied with LTC 8540/00 Ala rm Interface Unit 9 Pin D-Connector Power Supply (See Note) LT C 8540/00 Ala rm Interface Units (Rear View) Ala rm Inputs 1 to 64 9 Pin D-Connector (See Note) Ala rm Inputs 65 to128 9 Pin D-Connector (S
EN | 13 LTC 8713 Series | Instruction Manual | Illustrations LT C 8600 Series or LTC 8800 Serie s Allegia nt Serie s Main Bay (Rear View) Alarm Port Cable Supplied with LT C 8713 Serie s Alarm Port Expanders LT C 8713 Series Alarm Port Expa nder Hub (Rear View) Cables Supplied with LT C 8713 Ala rm Expander Units Ports 1, 2, 3, and 4 of LTC 8713 Series Ala rm Port Expander to Four LTC 8540/00 Ala rm Interface Units (Alarms 1 to 256) Ports 1, 2, 3, and 4 of LTC 8713 Series Alarm Port Expander to Four
LTC 8713 Series | Instruction Manual | Bosch Security Systems | 02 February 2004 EN | 14
LTC 8713 Series | Instruction Manual | Bosch Security Systems | 02 February 2004 EN | 15
Bosch Security Systems, Inc. 850 Greenfield Road Lancaster, PA 17601 USA Tel: 800-326-3270 Fax: 1-717-735-6560 www.boschsecuritysystems.com Bosch Security Systems B.V. P.O. Box 80002 5600 JB Eindhoven The Netherlands Tele +31 40 27 80000 © 2004 Bosch Security Systems GmbH 3935 890 04712 04-06 | February 04, 2004 | Data subject to change without notice. Bosch Security Systems Pte Ltd.