Installation Instruction
Table Of Contents
- Double oven
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Familiarising yourself with your appliance
- 5 Accessories
- 6 Before using for the first time
- 7 Basic operation
- 8 Time-setting options
- 9 Childproof lock
- 10 Rapid heating
- 11 Cleaning and servicing
- 12 Cleaning assistance
- 13 Shelf supports
- 14 Appliance door
- 14.1 Detaching the lower appliance door
- 14.2 Attaching the lower appliance door
- 14.3 Removing the door panes from the lower the appliance door
- 14.4 Installing the door panes for the lower the appliance door
- 14.5 Detaching the upper appliance door
- 14.6 Attaching the upper appliance door
- 14.7 Removing the door panes from the upper the appliance door
- 14.8 Installing the door panes for the upper the appliance door
- 15 Troubleshooting
- 16 Disposal
- 17 Customer Service
- 18 How it works
- 19 Installation instructions
Installation instructions en
29
¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡ The mains socket for the appliance must
either be located in the hatched area or
outside of the area where the appliance is
installed.
Any unsecured units must be secured to
the wall using a standard bracket .
¡ Wear protective gloves so that you do not
cut yourself. Parts that are accessible dur-
ing installation may have sharp edges.
¡ Dimensions of the figures in mm.
WARNING‒Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use multiple socket strips.
▶ Only use extension cables that are certified,
have a minimum cross section of 1.5mm²
and comply with the applicable national
safety requirements.
▶ If the power cord is too short, contact cus-
tomer service.
▶ Only use adapters approved by the manu-
facturer.
ATTENTION!
Carrying the appliance by the door handle
could break it. The door handle cannot sup-
port the weight of the appliance.
▶ Do not carry or hold the appliance by the
door handle.
19.2 Appliance dimensions
You will find the dimensions of the appliance here
19.3 Installation in a tall unit
Observe the installation dimensions and the installation
instructions when installing in a tall unit.
¡ To ventilate the appliance, there must be a gap of
20mm between all intermediate floors and the wall.
¡ If the tall unit has another back panel in addition to
the element back panels, this must be removed.
¡ Only fit the appliance up to a height which allows
accessories to be easily removed.