Installation Instruction
Table Of Contents
- Double oven
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Familiarising yourself with your appliance
- 5 Accessories
- 6 Before using for the first time
- 7 Basic operation
- 8 Time-setting options
- 9 Childproof lock
- 10 Rapid heating
- 11 Cleaning and servicing
- 12 Cleaning assistance
- 13 Shelf supports
- 14 Appliance door
- 14.1 Detaching the lower appliance door
- 14.2 Attaching the lower appliance door
- 14.3 Removing the door panes from the lower the appliance door
- 14.4 Installing the door panes for the lower the appliance door
- 14.5 Detaching the upper appliance door
- 14.6 Attaching the upper appliance door
- 14.7 Removing the door panes from the upper the appliance door
- 14.8 Installing the door panes for the upper the appliance door
- 15 Troubleshooting
- 16 Disposal
- 17 Customer Service
- 18 How it works
- 19 Installation instructions
en Installation instructions
30
19.4 Corner installation
Observe the installation dimensions and the installation
instructions when installing in a corner.
¡ To ensure that the appliance door can be opened,
you must take the minimum dimensions into consid-
eration when installing in a corner. The dimension
is dependent on the thickness of the unit front and
the handle.
19.5 Electrical connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
¡ The appliance corresponds to protection class I and
must only be operated with a protective earth con-
nection.
¡ The fuse protection must correspond to the power
rating specified on the appliance's rating plate and
to local regulations.
¡ The appliance must be disconnected from the
power supply whenever installation work is being
carried out.
¡ Contact protection must be guaranteed by the in-
stallation.
Electrically connecting an appliance without a
protective contact plug
Note:Only a licensed professional may connect the ap-
pliance. Damage caused by incorrect connection is not
covered under the warranty.
An all-pole isolating switch must be integrated into the
permanent electrical installation according to the install-
ation regulations.
1.
Identify the phase and neutral conductors in the
socket.
The appliance may be damaged if it is not connec-
ted correctly.
2.
Connect the hob in accordance with the connection
diagram.
The yellow/green wire for the safety earth terminal
must be 10mm longer on the appliance side than
the other wires.
See the rating plate for the voltage.
Connection 3N~ / 2N~ / 1N~: Use a H05VV-F
mains power cable or one with a higher rating.
19.6 Installing the appliance
1.
Remove the transport locks on the right and left and
then dispose of them.
2.
The appliance must be transported by two people
using the carry handles on the right and left, while
securing the front of the appliance with one hand.
3.
Place the appliance in the unit and fold the carry
handles down.
4.
Push the appliance in fully.
Do not kink or trap the connection cable, or route it
over sharp edges.