Technical data
Table Of Contents
- Title Page
- Table of Contents
- Safety
- Unpacking
- Product Description
- Electrical Connections
- Overview of Installation Steps
- Select the Mounting Location and Orientation
- Mount the Camera
- Earthing the Camera
- Finalize Camera Mounting
- Reverse the Rain Shield for Inverted Operation
- Install the MIC Power Supply Unit (PSU)
- Getting Started
- On-Screen Display (OSD) Menus (Bosch Protocol)
- On-Screen Display (OSD) Menus (Pelco Protocol)
- Common User Commands
- Programming the Inactivity Operation
- Setting AutoPan Mode
- Setting Preset Shots
- Specifying a Shot or a Sector Title
- Configuring Preposition Tours
- Remapping Aux Commands (Pelco Protocol, firmware version 2.10 and higher)
- Using the Wiper/Washer (Pelco Protocol)
- Using the Wiper/Washer (Bosch Protocol)
- Configuring Settings for IR Illumination
- Advanced Features
- Maintenance and Troubleshooting
- Technical data
- Appendices
- Back Page
Electrical Connections
About the MIC Shielded Composite Cable
All connections (power, telemetry, video) to the MIC camera are provided through the screw
terminal connections in the MIC power supply. MIC shielded composite cables are multi-
conductor cables of various lengths (and gauges ranging from 14 - 18) that provide all power,
video, and telemetry connections between the MIC PSU and the MIC camera. The cables are
pre-made with a female terminated connector (12-pin) at one end for attachment to the male
connector installed into the base of the camera. The other end of the cables has free (non-
terminated) wires for wiring into terminals in the MIC PSU. The composite cable consists of
two pairs (24AWG) plus 4 cores of (22 AWG), 2 cores of (24 AWG), and one coax core for the
video signal to a maximum distance of 25 m.
Notice!
Bosch Security Systems does not recommend using the shielded composite cable for
distances greater than 25 m between the MIC camera and the MIC power supply.
For installations that require the camera to be more than 25 m from the power supply, Bosch
recommends that a 2 m cable be connected to a junction box (Exd rated for MIC440) from
which telemetry, video, and power can be broken out into separate cables and appropriate
wiring used to extend the distance to suit.
!
Warning!
Bosch recommends connecting the cable to the unit before taking the unit for mounting on-
site.
MIC shielded composite cable before connection to a MIC550 or MIC550IR camera
MIC shielded composite cable connected to a MIC550 or MIC550IR camera
Composite Cable Color-coding
The standard color coding used in MIC composite cables is as follows:
4
4.1
4.2
MIC Series 550 Electrical Connections | en 15
Bosch Security Systems, Inc. Operation Manual November 2011 | | F.01U.239.454