Technical data
Table Of Contents
- Title Page
- Table of Contents
- Safety
- Unpacking
- Product Description
- Electrical Connections
- Overview of Installation Steps
- Select the Mounting Location and Orientation
- Mount the Camera
- Earthing the Camera
- Finalize Camera Mounting
- Reverse the Rain Shield for Inverted Operation
- Install the MIC Power Supply Unit (PSU)
- Getting Started
- On-Screen Display (OSD) Menus (Bosch Protocol)
- On-Screen Display (OSD) Menus (Pelco Protocol)
- Common User Commands
- Programming the Inactivity Operation
- Setting AutoPan Mode
- Setting Preset Shots
- Specifying a Shot or a Sector Title
- Configuring Preposition Tours
- Remapping Aux Commands (Pelco Protocol, firmware version 2.10 and higher)
- Using the Wiper/Washer (Pelco Protocol)
- Using the Wiper/Washer (Bosch Protocol)
- Configuring Settings for IR Illumination
- Advanced Features
- Maintenance and Troubleshooting
- Technical data
- Appendices
- Back Page
Privacy Masking
Allows masking of sensitive areas. Select option Mask and follow the on-screen instructions to
set a mask for up to 24 privacy masks are available, with a maximum limit of eight (8) to a
scene. For more details, refer to Privacy Masking, page 63.
Edit Sector Title
Allows editing of existing Sector (Zone) Titles. Select a sector title to access the character
palette. For instructions, refer to Specifying a Shot or a Sector Title, page 58.
Edit Scene Title
Allows editing existing Scene (Shot) Titles. Select a scene title, and then select a menu
option:
– Edit Scene Title to access the character palette. For instructions, refer to Specifying a
Shot or a Sector Title, page 58.
– Clear Scene to delete the selected scene title.
Communication Setup Menu
The Communication Setup Menu contains baud rate and Bilinx control settings.
Communication Setup
Exit...
* AutoBaud: ON
* Baud Rate: 9600
Bilinx
Restore Defaults
* = Factory Setting
Focus / Iris: Select
AutoBaud
Turns on AutoBaud detection, which detects and adjusts the camera protocol and baud rate to
match that of the controller. Options: ON (default setting), OFF. ON automatically accepts
baud rates from 2400 to 57600.
Note: If stepping from 2400 to 57600 baud, you must first set the Baud Rate to 19200 for
AutoBaud to detect the higher baud rate.
13.5
MIC Series 550 On-Screen Display (OSD) Menus (Bosch Protocol) | en 43
Bosch Security Systems, Inc. Operation Manual November 2011 | | F.01U.239.454