Installation Manual

32 en | Getting Started MIC612 Thermal Camera
F.01U.249.416 | 1.1 | 2012.03 Installation Manual Bosch Security Systems, Inc.
The figure below illustrates the connection configuration of a MIC612, a matrix switcher, a
monitor, and a keyboard.
5.4.1 Setting the Address of the Optical Camera via FastAddress
The MIC612 offers remote addressing of the optical camera via the feature "FastAddress,"
which allows you to set or to change a camera address using the keyboard and on-screen
menus. The FastAddress feature allows you to install all cameras first, then to set the
addresses via the control system. This feature makes it easier to re-address cameras at a later
time because you do not need to go to the physical location of the camera to change the
camera’s address.
5.4.2 FastAddress, Bosch Protocol
In Bosch protocol, there are three (3) FastAddress commands:
– ON-999-ENTER: Displays and programs all cameras without an address in the system.
Number Description
1 Viewing window of optical camera
2 Viewing viewing of thermal camera
3 Connection from optical camera to matrix switcher
4 Switchable connection (via Aux commands) from optical camera or
thermal camera to matrix switcher
5 Matrix switcher
6Monitor
7Keyboard
NOTICE!
You do not need to set a camera address if using Bilinx communication.
FastAddress is stored in nonvolatile memory and does not change if the power is turned off or
if the default settings are restored.
NOTICE!
If a keyboard is set to a camera number that already has an address, that camera also
responds to this command.