Installation Manual
58 en | Common User Commands MIC612 Thermal Camera
F.01U.249.416 | 1.1 | 2012.03 Installation Manual Bosch Security Systems, Inc.
9.6 Recording Tours
The MIC612 can make up to two (2) recorded tours. A Recorded Tour saves all manual
camera movements made during the recording, including its rate of pan, tilt and zoom speeds
and other lens setting changes.
To Record Tour A:
1. Press ON-100-ENTER to start recording a tour.
2. Press OFF-100-ENTER to stop recording.
To playback Recorded Tour A:
1. Press ON-50-ENTER to begin continuous playback.
2. Press OFF-50-ENTER or move the joystick to stop playback.
To Record Tour B:
1. Press ON-101-ENTER to start recording the tour.
2. Press OFF-101-ENTER to stop the tour.
To playback Recorded Tour B:
1. Press ON-52-ENTER to begin continuous playback.
2. Press OFF-52-ENTER or move the joystick to stop playback.
9.7 Using the Wiper/Washer
The "predefined position" for the wash/wipe function is preset 62. The installer must define
preset 62 (preferably where the washer nozzle is located and can direct washer fluid towards
the camera window) before using the wiper/washer function.
To activate the washer/wiper function:
1. Press ON-105-ENTER, and then confirm this sequence:
2. The wiper moves to a predefined position.
3. The washer turns on for five seconds. Simultaneously, the wiper turns on and wipes five
times.
4. The washer turns off. The wiper continues wiping for five more wipes as the camera
returns to its initial PTZ position (and to inactive mode if applicable).
5. The wiper turns off.
To activate continuous wipe:
Press ON-102-ENTER. The wiper wipes continuously for up to 5 minutes, or until another
OFF-102-ENTER command is sent (if the command is sent before the 5 minutes elapse).
The wiper then turns off automatically.
To activate intermittent wipe:
Press ON-103-ENTER. The wiper wipes twice, then returns to parked position, and turns
off 15 seconds later. This sequence will continue for up to 5 minutes or until an OFF-103-
ENTER command is sent.
To activate the wiper to wipe five (5) times:
Press ON-104-ENTER. The wiper wipes five (5) times, or until an OFF-104-ENTER
command is sent (if the command is sent before the wiper wipes five (5) times), then
returns to parked position and turns off.
NOTICE!
If the power fails while the wiper is activated, the wiper will return to ’parked’ position, after
power is restored, before turning off. The wiper will not stop in front of the camera window.