User Manual

MIC IP ultra 7100i │ MIC IP starlight 7100i Network | en 55
Bosch Security Systems User Manual 2020-02 | 1.1 |
8 Network
8.1 Network Services
This page shows an overview of all available network services. Use the checkbox to activate or
deactivate a network service. Click on the settings symbol next to the network service to go to
the settings page for this network service.
From the list on the page, select the appropriate network services that are required for
activated functionality:
– HTTP
– HTTPS
– RTSP
– RCP
– iSCSI
– NTP server
– Discovery
– ONVIF discovery
– Password reset mechanism
– Ping response
Note: You can disable Password reset mechanism.
Note: The following services and their respective ports are deactivated.
– FTP
– SNMP
– UPnP
– GB/T 28181
8.2 Network Access
The settings on this page are used to integrate the camera into an existing network.
Automatic IPv4 assignment
If the network has a DHCP server for the dynamic assignment of IP addresses, select On or On
plus Link-Local to automatically accept the DHCP-assigned IP address.
If no DHCP server is available select On plus Link-Local to automatically assign a Link-Local
(Auto-IP) address.
For certain applications, the DHCP server must support the fixed assignment between IP
address and MAC address, and must be appropriately set up so that, once an IP address is
assigned, it is retained each time the system is rebooted.
IPv4
Fill in the 3 fields in this section of the screen.
IP address
Enter the desired IP address for the camera in this field. The IP address must be valid for the
network.
Subnet mask
Enter the appropriate subnet mask for the selected IP address here.
Gateway address
If you want the unit to establish a connection to a remote location in a different subnet, enter
the IP address of the gateway here. Otherwise leave the box blank (0.0.0.0).
IPv6
Consult with the network administrator before making changes to this section.