User Manual

26 en | Installation MIC Series IP Power Supply
F.01U.265.804 | 1.6 | 2012.08 User Manual Bosch Security Systems, Inc.
3.9 Simultaneous IP and Analog Video/Control ("Hybrid"
Operation)
The figure below illustrates how to configure your system to achieve simultaneous video and
control over both IP and analog connections.
Figure 3.15 System configuration for simultaneous video/control
3.10 Assign an IP Address
Assign an IP address to the encoder. The encoder must have a valid IP address for your
network and a compatible subnet mask before you can operate it within your network.
1. If you have not already done so, install the Configuration Manager program from the
product CD.
2. Start Configuration Manager. The system automatically searches the network for
compatible units.
3. If the encoder is displayed in the list, right-click the entry, then select Device Network
Settings... from the popup menu that appears.
4. In the Device IP address field, enter the required IP address (for example 192.168.0.100)
and click OK. The encoder reboots and the IP address is valid.
Number Description
1 Connection between MIC camera and BNC T-connector in BNC socket on PCB in
MIC IP PSU
2 Connection between BNC T-connector and encoder in MIC IP PSU
3 Connection between BNC T-connector and Bilinx-based control (head-end) system
4 Connection between encoder and Local Area Network (LAN) (or the "cloud")
5 Connection between the Local Area Network (LAN) (or the "cloud") and PC
connected to video monitor
Bilinx