User Manual

MIC Series IP Power Supply Configuration using a Web browser | en 73
Bosch Security Systems, Inc. User Manual F.01U.265.804 | 1.6 | 2012.08
4.42 Advanced Mode: Network
4.43 Network Access
The settings on this page are used to integrate the encoder into an existing network.
Some changes only take effect after the unit is rebooted. In this case, the Set button changes
to Set and Reboot.
1. Make the desired changes.
2. Click the Set and Reboot button. The encoder is rebooted and the changed settings are
activated.
Automatic IP assignment
If a DHCP server is employed in the network for the dynamic assignment of IP addresses, you
can activate acceptance of IP addresses automatically assigned to the encoder.
Certain applications (for example, Bosch Video Management System) use the IP address for
the unique assignment of the unit. If you use these applications, the DHCP server must
support the fixed assignment between IP address and MAC address, and must be
CAUTION!
If you change the IP address, subnet mask or gateway address, the encoder is only available
under the new addresses after the reboot.