User Manual

MIC Series IP Power Supply Maintenance and upgrades | en 93
Bosch Security Systems, Inc. User Manual F.01U.265.804 | 1.6 | 2012.08
6.5 Fiber Optic Module
The unit is not
operational after a
firmware upload.
Power failure during
programming by firmware file.
Have the unit checked by Customer
Service and replace if necessary.
Incorrect firmware file. Enter the IP address of the unit
followed by /main.htm in your Web
browser and repeat the upload.
Placeholder with a red
cross instead of the
ActiveX components.
JVM not installed on your
computer or not activated.
Install Sun JVM from the product
CD.
Web browser contains
empty fields.
Active proxy server in network. Create a rule in the local
computer's proxy settings to
exclude local IP addresses.
The POWER LED
flashes red.
Firmware upload failed. Repeat firmware upload.
Malfunction Possible causes Recommended solution
Issue Symptom Resolution
No data present No Power Check power to the module:
– If Green LED is present, then
Check power to CNFE2MC:
– If Power LED is Green, then check data link
Invalid Fiber Link Check fiber connection to the module:
– If Red LED is present, then the fiber link is
missing. If the LED is Flashing Red, then
Check the fiber connection to the CNFE2MC:
– If the Link/Act LED is not lit, then the fiber link is
missing.
No Video present RJ-45 Connection Check the PWR/Link on the module:
– If the LED is slowly Flashing Red, then
Check all video connections from the camera.
– If the LED is rapidly Flashing Red, then
Check the RJ-45 connector on the module:
– If the right LED (Green) is not lit, then no data is
present at this RJ-45 connection.
– If no LED lit on the RJ-45 connector, then there is
a fault with this connector, the RJ-45 cable, or the
cable is not connected to the CNFE2MC.
Check the RJ-45 connector on the CNFE2MC:
– If the right LED (Green) is not lit, then no data is
present at this RJ-45 connection.
– If no LED lit on the RJ-45 connector, then there is
a fault with this connector, the RJ-45 cable, or the
cable is not connected to the module.