Operation Manual

View Control ROI
When the Stream 2 encoder stream is set for Region of Interest
(ROI), a specific type of View Control panel is activated for
electronic pan, tilt and zoom control (E-PTZ).
Refer to Encoder Streams, page 57 for more information on
setting up Stream 2. (If dual ROI is available, open the camera in
a second browser window to set up the second ROI on Stream
2.)
Zoom
To zoom in on a region of the stream 2 image:
1. Click and hold to zoom in; click and hold to
zoom out.
2. Click
to see the full image.
Select an area
To select a particular region of the image:
1. Click and hold the arrows to move up and down, and from
side to side through the image.
2. Click and hold the center area to move in all directions.
Set positions
To store the current view:
1. Select a region of interest.
2. Click Set.
3. Click a number.
To display a pre-set region of interest, click one of the buttons
numbered one to six.
3.1.3
16 en | Operation via the browser
Camera Browser
Interface
2014.01 | v5.9 | AM18-Q0670 Bosch Security Systems