Operation Manual

Network Management
SNMP
The camera supports the SNMP V1 (Simple Network
Management Protocol) for managing and monitoring network
components, and can send SNMP messages (traps) to IP
addresses. It supports SNMP MIB II in the unified code.
If On is selected for the SNMP parameter and a SNMP host
address is not entered, the device does not send the traps
automatically and will only reply to SNMP requests. If one or
two SNMP host addresses are entered, SNMP traps are sent
automatically. Select Off to deactivate the SNMP function.
SNMP host addresses
To send SNMP traps automatically, enter the IP address of one
or two target devices here.
SNMP traps
To choose which traps are sent:
1. Click Select. A dialog box appears.
2. Click the check boxes of the appropriate traps.
3. Click Set to close the window and send all of the checked
traps.
UPnP
Select On to activate UPnP communication. Select Off to
deactivate it.
When the Universal Plug-and-Play (UPnP) function is activated,
the unit responds to requests from the network and is
automatically registered on the requesting computers as a new
network device. This function should not be used in large
installations due to the large number of registration
notifications.
13.4
13.4.1
13.4.2
98 en | Network
Camera Browser
Interface
2014.01 | v5.9 | AM18-Q0670 Bosch Security Systems