Manual
Table Of Contents
- Title Page
- Table of Contents
- Browser connection
- System overview
- Operation via the browser
- Basic Mode
- General settings
- Web Interface
- Camera
- Encoder Settings
- Recording
- Alarm
- Setting up VCA
- Interfaces
- Network
- Service
- Back Page
IPv4 Filter
To restrict the range of IP addresses within which you can
actively connect to the device, fill-in an IP address and mask.
Two ranges can be defined.
4 Click Set and confirm to restrict access.
If either of these ranges are set, no IP V6 addresses are allowed
to actively connect to the device.
The device itself may initiate a connection (for example, to send
an alarm) outside the defined ranges if it is configured to do so.
13.8
104 en | Network
Camera Browser
Interface
2014.01 | v5.9 | AM18-Q0670 Bosch Security Systems