Manual

3. Click Upload to begin transferring the file to the device. The
progress bar allows monitoring of the transfer.
The new firmware is unpacked and the Flash memory is
reprogrammed. The time remaining is shown by the message
going to reset Reconnecting in ... seconds. When the upload is
completed successfully, the device reboots automatically.
If the operating status LED lights up red, the upload has failed
and must be repeated. To perform the upload, switch to a
special page:
1. In the address bar of your browser, enter /main.htm after
the device IP address, for example:
192.168.0.10/main.htm
2. Repeat the upload.
Upload History
Click Show to view the firmware upload history.
Configuration
Save configuration data for the device to a computer and load
saved configuration data from a computer to the device.
To load configuration data from the computer to the device:
1. Click Load From... ; a dialog box appears.
Make certain that the file to be loaded comes from the
same device type as the device to be reconfigured.
2. Locate and open the desired configuration file.
The progress bar allows monitoring of the transfer.
To save the camera settings:
1. Click Save As...; a dialog box appears.
2. Enter a file name if required and save.
SSL certificate
To work with an SSL connection, both sides of the connection
must have the appropriate certificates. Upload one or more
certificate files, one at a time, to the camera.
14.1.3
14.1.4
14.1.5
106 en | Service
Camera Browser
Interface
2014.07 | v1.592 | AM18-Q0678 Bosch Security Systems