Manual

– Change the time interval displayed by clicking the plus or
minus icons. The display can span a range from two months
to a few seconds.
– If required, click in the bar at the point in time at which the
playback should begin.
– Red bars indicate the points in time where alarms were
triggered.
To view the current live image, click Now.
Controls
Control playback by means of the buttons below the video
image.
Use the jog dial to quickly scan the
sequences. The time code is displayed above it.
The buttons have the following functions:
Start/Pause playback
Select the playback speed using the speed regulator:
Jump to start of active sequence or to previous sequence
Jump to start of the next video sequence in the list
Bookmarks
You can set markers in a sequence and jump to these directly.
These bookmarks are indicated as small yellow arrows above
the time interval. Use the bookmarks as follows:
Jump to the previous bookmark
Set bookmark
Jump to the following bookmark
Bookmarks are only valid while in the Recordings page; they are
not saved with the sequences. All bookmarks are deleted when
you leave the page.
22
en | Operation via the browser
Camera Browser
Interface
2014.07 | v1.592 | AM18-Q0678 Bosch Security Systems